Setting Up Software - Analog Devices EVAL-AD2428WD1BZ Manual

Using the Software
1. Assemble the example A
• Master (EVAL-AD2428WD1BZ) – Connect the B-side (P2) to the A-side on the slave0 board (J7)
• Slave0 (EVAL-AD2428WC1BZ) – Connect the B-side (J8) to the A-side on the slave1 board (J7)
• Slave1 (EVAL-AD2428WB1BZ)
2. Connect the PC over a USB cable and using the EVAL-ADUSB2EBZ USBi I
dio header (P1) on the master board.
3. Connect an audio source to the stereo line input of the slave1 board (J2).
4. Connect headphones to the audio output of the master board (J4).
5. Plug the wall-mount 12V power supply (1.5 A) into an outlet and connect it to the power jack on the master
board (P4).

Setting up Software

Use the following programming sequence to set up and operate the A
1. Install the SigmaStudio (Rev. 4.4 or later) and A
ware from the EVAL-AD2428WD1BZ product page.
2. Copy the A2B.dll and A2Bstack.dll driver files from the installation directory (default) C:\Analog
Devices\ADI_A2B_Software-Rel19.3.0\GUI\x86_x64) into the SigmaStudio installation
( (default) C:\Program Files\Analog Devices\SigmaStudio 4.4). Start SigmaStudio and
verify that the A2B.dll file is selected under Tools→AddInsBrowser. Save before exiting.
3. Open the adi_a2b_3NodeSampleDemo.dspproj example project, which is located in the (default)
C:\Analog Devices\ADI_A2B_Software-Rel19.3.0\Schematics\BF
\A2BSchematics directory. Click the Link-Compile-Download icon, as shown in the Software Schematic
for adi_a2b_3NodeSampleDemoConfig.dspproj A
2–8
2
B system by connecting the indicated A
2
B evaluation boards as follows:
2
B Software.
2
B Software for Windows/Baremetal (Rev 19.3.0 or later) soft-
2
B Example Project figure.
EVAL-AD2428WD1BZ A
2
C programmer to the SigmaStu-
2
B Evaluation Board Manual