Leviton Lumina ZS057-ALZ Installation Instructions

WARNINGS
• TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF POWER AT CIRCUIT
BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE WIRING!
• To be installed and/or used in accordance with appropriate electrical codes
and regulations.
• If you are unsure about any part of these instructions, consult an electrician.
Before Installation
• Install into any single-gang device back box.
• Supports multi-gang installations.
• Requires Decora ® faceplate, sold separately.
• Devices use 0-10VDC low voltage control wires which may be installed as Class 1 or Class 2.
IMPORTANT: If installed as Class 2, all devices in the circuit must be Class 2 rated and this dimmer must be wired per instructions below.
0-10V Dimming Installation
For 0-10V control wiring: connect the VIOLET wire to the +0-10V line and the GRAY wire to the 0-10V COMMON using Class 1 or Class 2 wiring
authority having jurisdiction with respect to wire type, sleeving, isolation methods, and the like. Separation must be provided if Class 2 circuit is installed
NOTE THE FOLLOWING:
• Connectors joining 0-10V control wires should be approved LISTED CONNECTORS.
• Wire connectors and wire tubing should be provided by the installation contractor.
WARNING: TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF
POWER at circuit breaker or fuse and test that power is off
before wiring!
1.
Strip wires 3/4 in. and connect as per wiring diagram. Ensure
ZS057-ALZ BACKBOX
BLACK RED
WHITE BLACK
BLUE ORANGE/YELLOW
GREEN GREEN
VIOLET VIOLET
GRAY GRAY
2.
Gently place the wires and your device into the wall box and attach
with screws provided.
3.
4.
If desired, change switch color.
5.
Install Decora faceplate.
0-10VDC Low Voltage RF Wall Dimmer
Cat. No. ZS057-ALZ, Ratings: 24VDC, 20mA
INSTALLATION INSTRUCTIONS
PURPOSE
+24VDC
COMMON
LOCAL SWITCH
GROUND
CAUTIONS
• Use this device with copper or copper clad wire only.
• For indoor applications only.
• Save these instructions.
Zone A
Lighting Line
Circuit
Line Feed NEU
Lighting
Load
BLU
BLU
Powerpack
BLK
OPP20-0D2
WHT
Same Class Wiring Installation Shown
White
Blue
Black
Green
Violet
Gray
To release, push sides.
DI-003-ZS057-02A
ENGLISH
VIO
GRY
BLU
BLU (SIG)
RED (+V/+24V)
BLK (COM)
BLU/WHT (MANUAL ON)
Low Voltage
ORG/YEL (LOCAL SW INPUT)
Occupancy
Sensor
Orange/Yellow
Black
Red
Ground
Line up and press in to attach.
BLK
WHT