Page 4
Use of other accessories may not ensure compliance with FCC RF exposure guidelines. European Conformity Statement unitech Electronics co., Ltd herewith declares that the unitech product is in compliance with the essential requirements and all other provisions of the RED 2014/53/EU directive.
Page 6
Waste electrical and electronic equipment (WEEE) unitech has set up a policy and process to meet the 2012/19/EU concerning electronic waste disposal. For more detailed information of the electronic waste disposal of the products you have purchased from unitech directly or via unitech’s resellers, you shall either...
Page 8
Laser Information The unitech product is certified in the U.S. to conform to the requirements of DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 60825-1. Class II and Class 2 products are not considered to be hazardous. The unitech product contains internally a Visible Laser Diode (VLD) whose emissions do not exceed the maximum limits as set forth in the above regulations.
Page 10
It may not be functional anymore. Please only use the original battery from unitech. Using a third party battery can damage our products. Please note that when such damage occurs, it is not covered by unitech’s warranty policy.
Page 12
Please remove the power adapter when the battery is fully recharged. The bundled power adapter that comes with your unitech product is not meant to be used outdoors. An adapter exposed to water or rain, or a very humid environment can cause damage to both the adapter and the product.
Page 14
Worldwide Support unitech’s professional support team is available to quickly answer questions or assist with technical-related issues. Should an equipment problem occur, please contact the nearest unitech regional service representative. For complete contact information please visit the Web sites listed below: Taipei, Taiwan –...
Page 15
The warranty period is varied from each country. Please consult with your supplier or unitech local office for actual length of warranty period to your purchased product. Warranty becomes void if equipment is modified, improperly installed or used, damaged by accident or neglect, or if any parts are improperly installed or replaced by the user.
Page 17
HT730 User’s Manual Chapter 1 - Overview 1.1 Package Please make sure the following contents are in the HT730 gift box. If something is missing or damaged, please contact your unitech representative. The basic package contents HT730 Battery ...
Page 24
It takes within 4 hours to charge the terminal with the cradle to full capacity. Connect the type C USB cable to the USB port on HT730 and connect the other end of the USB cable to AC power adapter. Then plug into the electrical outlet.
Page 25
HT730 User’s Manual 1.4.3 Turning on the terminal for the first time It is recommended to fully charge HT730 before first use. You can now start up your device to set up the languages, WLAN setting, and date and time.
Page 26
HT730 User’s Manual 1.4.5 Using the Micro SD/ Nano SIM Card The HT730 has 1 x micro SD and 2 x nano SIM card slots inside the battery compartment. Note: Please TURN OFF the terminal, before inserting or removing micro SD card or...
Need help?
Do you have a question about the HT730 and is the answer not in the manual?
Questions and answers