Wyze WSPRK1 Manual

Wyze WSPRK1 Manual

Sprinkler controller

Advertisement

WYZE SPRINKLER CONTROLLER
Manual
WSPRK1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WSPRK1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Wyze WSPRK1

  • Page 1 WYZE SPRINKLER CONTROLLER Manual WSPRK1...
  • Page 2 Introduction Congratulations on purchasing a Wyze Sprinkler Controller. This Quick Reference Guide describes how to install, operate, and maintain your controller. Please read the instructions below. Package List Mount screws and anchors power adapter Sprinkler Controller...
  • Page 3 Controller Stations Wyze Sprinkler is an 8-station controller. Each station is connected to a sprinkler valve. The specific valve turns on when it receives a signal from the controller, and then the sprinkler will start watering. When the watering task is finished, the controller will shut off the valve and turn on the next one in sequence.
  • Page 4 Step 2 Installing anchors Tap the anchors into the holes on the wall. Step 3 Mounting Screw the mount on the wall. Step 4 Wiring Connect power adapter, valve wires and sensors to corresponding terminals.
  • Page 5 Step 6 App setup Download the Wyze APP and select “Add a product”, then the app will guide you to complete the setup process. After finishing the system setup, you can create the irrigation tasks.
  • Page 6 Manual Controls You can run the zone watering easily on the device. Press the left and right button to select a zone. Press the WATERING button (the upper one) to start a quick run immediately and press the STOP button (the lower one) to stop the watering. Troubleshooting One or more stations do not turn on: 1.
  • Page 7 FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the followi ng two conditions: (1) this device may not cause harmful interference, and (2) this de vice must accept any interference received, including interference that may c ause undesired operation.
  • Page 8 This radio transmitter (ISED certification number: 26041-WSPRK1) has been approved by Industry Canada to operate with theantenna types listed with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with thisdevice.

Table of Contents