Charge Amps Halo Wallbox Installation Manual
Hide thumbs
Also See for Halo Wallbox:
- User and installation manual (15 pages) ,
- Installation manual (4 pages)
Related Manuals for Charge Amps Halo Wallbox
Summary of Contents for Charge Amps Halo Wallbox
- Page 1 CHARGE AMPS Halo Wallbox for InCharge Installation manual Halo Wallbox 3.7 kW, 7.4 kW and 11 kW...
-
Page 2: Table Of Contents
Status indications on Halo ........................8 Halo error indications ..........................9 Rights ............................... 9 Drill Template appendix ......................... 10 CHARGE AMPS Installation manual for Halo Wallbox for InCharge | © 2020 Charge Amps AB Frösundaleden 4B 130040, rev 01 169 75 Solna Sweden www.chargeamps.com... -
Page 3: Greetings Installer
Greetings installer! This installation manual is intended for qualified Halo Wallbox installers and describes how to install the product safely and properly. Installation may only be carried out by a qualified installer who follows: • Basic safety precautions for safe and correct installation. -
Page 4: About Halo
7. Charging cable entry: fixed charging cable 8. Plastic Membrane 9. Cable entry: incoming electrical connection 10. Cable entry: LAN connection CHARGE AMPS Installation manual for Halo Wallbox for InCharge | © 2020 Charge Amps AB Frösundaleden 4B 130040, rev 01 169 75 Solna Sweden www.chargeamps.com... -
Page 5: Contents Of The Package
• Sealant (if necessary) if the wall for mounting is uneven and exposed to an outdoor climate CHARGE AMPS Installation manual for Halo Wallbox for InCharge | © 2020 Charge Amps AB Frösundaleden 4B 130040, rev 01 169 75 Solna Sweden... -
Page 6: Cabling
Unpack the Halo from its box. Check that the product is in good condition and that all cables are properly seated. CHARGE AMPS Installation manual for Halo Wallbox for InCharge | © 2020 Charge Amps AB Frösundaleden 4B 130040, rev 01 169 75 Solna Sweden www.chargeamps.com... - Page 7 Connection of 1-phase in TN network In a 1-phase connection, make the following connections. b. Connection of 1-phase in IT network CHARGE AMPS Installation manual for Halo Wallbox for InCharge | © 2020 Charge Amps AB Frösundaleden 4B 130040, rev 01 169 75 Solna Sweden...
- Page 8 If interference exists, this will break and damage the ethernet port of the Halo. CHARGE AMPS Installation manual for Halo Wallbox for InCharge | © 2020 Charge Amps AB Frösundaleden 4B 130040, rev 01 169 75 Solna Sweden www.chargeamps.com...
-
Page 9: Configuring Electrical Parameters For Halo
Vattenfall Customer service. Status indications on Halo Halo uses light to communicate its status in different ways. CHARGE AMPS Installation manual for Halo Wallbox for InCharge | © 2020 Charge Amps AB Frösundaleden 4B 130040, rev 01 169 75 Solna Sweden... -
Page 10: Halo Error Indications
If none of these actions remedy the problem, contact the supplier for support. Rights The information in this document has been checked for accuracy. Charge Amps AB reserves the right to make technical changes and changes to the contents of the document without prior notice. Charge Amps AB can not guarantee that all of the content of this particular document is accurate, up-to-date, and free from printing and proofreading errors. -
Page 11: Drill Template Appendix
Charge Amps AB reserves all rights to this document, as well as the information and illustrations therein. It is strictly forbidden to – in whole or in part – copy, adapt or translate the information without prior written permission from Charge Amps AB.
Need help?
Do you have a question about the Halo Wallbox and is the answer not in the manual?
Questions and answers