Testing And Verification; Static Load Test; Dynamic Load Test - Zepro Z 1500-135 Installation Instructions Manual

Testing and verification
16

Testing and verification

Testing and verification of the tail lift takes place in accordance with the installation/delivery inspection. Verify
that the tail lift is suitable for the vehicle in question and for the intended use.
16.1

Static load test

16.1.1
• Position the tail lift half way up to the vehicle floor level and with the platform in the horizontal position.
Measure dimensions A-B-C-D for comparison as illustrated.Image 103.
• Place a test load on the platform according to the table for the respective tail lift model and lifting capac-
ity.
• Remove the test load from the platform.
• Repeat the measurement of A-B-C-D and verify that there has been no deformation of the lift or its fixing.
16.1.2
• Place a test load on the platform according to the table. The tail lift must be at the same level and angle
as the vehicle floor.
Leave the test load for 15 minutes.
• Verify that the platform drift is no more than 15 mm on the vertical (points A and D) and 2º in terms of the
angle.
16.1.3
with load centre of 1000 mm
Capacity Load 1500 kg
Distance out in platform (L)
1500 kg 1250 mm
2000 kg 1625 mm
C
76
Deformation
Drift
Static load (Test load 1.25 x tail lift loading capacity). For tail lifts
Load 2000 kg
-
1250 mm
D
B
Deformation
Max 2º
Image 103. Testing and verification
A
D
C
B
Drift
Z 1500/2000-135/155/175
A
Max. 15 mm
www.zepro.com