Page 1
NO PREP DRAG 1/10 2WD RTR Battery and Charger Battery and Charger Not Included Not Included INSTRUCTION MANUAL BEDIENUNGSANLEITUNG Before operating this vehicle, please read all printed materials thoroughly. MANUEL D’UTILISATION Horizon Hobby is not responsible for inadvertent errors in this manual. MANUALE DI ISTRUZIONI...
This product is not intended for use by children without direct adult supervision. Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and mainte- nance.
WATER-RESISTANT VEHICLE WITH WATERPROOF ELECTRONICS WET CONDITIONS MAINTENANCE Your new Horizon Hobby vehicle has been designed and built with a combination of waterproof and water-resistant components to allow you to operate the product in many • Drain any water that has collected in the tires by spinning them at high speed. With the “wet conditions,”...
INSTALLING THE BATTERY 1. Ensure the ESC is powered OFF. 2. Remove the body clips and lift the vehicle body. 3. Remove the elastomer straps from the battery posts. 4. Install the fully charged battery in the vehicle. 5. Resecure the elastomer straps. 6.
SPMSR315 DUAL PROTOCOL RECEIVER Specifications Type: Dual Protocol 3 Ch Receiver* (SLT/DSMR) Dimensions (LxWxH): 32.5 x 21.5 x 12.4mm Antenna Length: 90mm Channels: 3 Weight: 6g Band: 2.4GHz Voltage Range: 3.5–9.6V Bind Type: Bind Button Failsafe: Hold the steering wheel and throttle trigger in the desired failsafe positions during binding BATT *SPMSR315 receivers included with the SLT3 transmitter include SLT and DSMR compatibility.
BEFORE RUNNING YOUR VEHICLE PERFORMING A CONTROL DIRECTION TEST 1. Check for free suspension movement. All suspension arms and steering components should move freely. Any binds will cause the vehicle to handle poorly. Tip: To increase the ride height and ground clearance of your vehicle, install the included shock spacers.
DESCRIPTIONS Battery Type BEC Voltage This setting allows you to change the battery chemistry. Changing this setting only changes Adjusts the voltage that is delivered to the receiver. The BEC (battery eliminator circuit) al- the cut off voltage. Selecting LiPo will prevent over discharge of your LiPo battery. Selecting lows for a single battery to power both the motor and radio gear.
Resolder the motor wire with the proper equipment Motor does not run Motor wire broken Repair or replace as needed ESC damaged Contact Horizon Hobby Product Support Motor over-geared Use smaller pinion or larger spur gear ESC gets hot Driveline bound up...
(iii) modification of or to any part of the Product, (iv) as Horizon is not responsible for merchandise until it arrives and is accepted at our facility. attempted service by anyone other than a Horizon Hobby authorized service center, (v) Product An Online Service Request is available at http://www.horizonhobby.com/content/service- not purchased from an authorized Horizon dealer, or (vi) Product not compliant with applicable center_render-service-center.
EU Compliance Statement: EU Manufacturer of Record: Horizon Hobby, LLC Hereby, Horizon Hobby, LLC declares that the device is in compliance with 2904 Research Road the following: EU Radio Equipment Directive 2014/53/EU; RoHS 2 Directive 2011/65/EU; RoHS 3 Directive - Amending 2011/65/EU Annex II 2015/863.
Need help?
Do you have a question about the Losi 22S and is the answer not in the manual?
Questions and answers