Table of Contents
Advertisement
Available languages
Available languages
Installation manual
Installing Instructions - Anti - Tip Bracket
IMPORTANT:
Determine the final location of the appliance before attempting to install the bracket.
You will need to choose one of the three installation methods below.
Ø
3 /
" (Ø 8mm)
8
Check the bracket : After installing the bracket, try using light force to tip the unit. If
the unit does not tip then bracket mounted securely. If the unit does tip, the bracket
MUST be reinstalled following these instructions.
DRYWALL installation:
1. After you have chosen the installation location, Place
the bracket on the floor with Loc b against the wall, use
Screw (E) (2pcs) to secure the bracket to the wall.
Ensure at least one screw is secured into a stud.
2. Move the unit to align Loc e to bracket Loc a, secure
with the bolt (B), lock washer (C) and flat washer (D)
NOTE
The screws MUST enter into a wood stud.
If the wall contains metal studs or similar materials, then
the floor installation must be used
WOOD FLOOR installation
1. After you have chosen the installation location, Place
the bracket on the floor, use : Screw (E) (2pcs) to secure
the bracket to the wall.
2. Move the unit to align Loc e to bracket Loc a, secure
with the bolt (B), lock washer (C) and flat washer (D)
CONCRETE FLOOR installation
1. After you have chosen the installation location,
choose any hole of Loc d to secure the bracked into the
concrete floor.
2. Using a concrete bit, drill Ø3/8" (Ø8mm) pilot hole
1.7"~2.4" (45mm~60mm) deep
3. Remove the nut, spring washer and washer of the
expansion screw.
4. Carefully tap the expansion screw into the concrete,
using a hammer or mallet.
5. Align Loc d and secure the nut, spring washer, washer
tightly back on the expansion screw and fix on the
concrete floor.
6. Move the unit to align Loc e to bracket Loc a, secure
with the bolt(B), lock washer (C) and flat washer (D).
6
Advertisement
Table of Contents
