Wireless Antennas And Cables (Installed On Top Cover) - HP Elite Folio Maintenance And Service Manual

3. Remove the three Phillips M2.0 × 2.0 screws (3) that secure the touchpad to the computer.
4. Rotate the touchpad upward to a 20° to 30° angle (4), and then pull the touchpad away from the
computer at an angle to remove it (5).
Reverse this procedure to install the touchpad.
IMPORTANT:
the computer, lift the top cover/keyboard up off the display.

Wireless antennas and cables (installed on top cover)

To remove the wireless antennas and cables that are installed on the top cover, use this procedure and
illustration.
Table 6-4 Wireless antennas and cables description and part number
Description
Wireless antennas and cables (main)
Wireless antennas and cables (aux)
Before removing the wireless antennas and cables, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the pen (see
3. Remove the bottom cover (see
4. Remove the battery (see
Remove the wireless antennas and cables:
1. Disconnect the antenna cables from the WLAN module (1).
2. Remove the cables from their routing under the keyboard cable and around to the left antenna (2).
To avoid damaging the display during touchpad installation, before inserting the touchpad into
Pen on page
Bottom cover on page
Battery on page
Preparation for disassembly on page
28).
30).
31).
Spare part number
M35272-001
M35273-001
28).
Component replacement procedures 35