Add An X10 Address; Factory Reset; Specifications - INSTEON FanLinc Manual

Does not provide a phase bridge to FanLinc
Relocate if necessary (and practical)
 If the "other" dual-band device is exhibiting any other behavior or color, refer to its owners
manual
Tap FanLinc light set button
3)
FanLinc will stop beeping
FanLinc light LED will turn
Other device LEDs will stop blinking

Add an X10 Address

For the fan
1) Press & hold FanLinc fan set button until it beeps
FanLinc LED will start blinking
2) Send the desired X10 address, plus on, 3 times (e.g. send B5, BON, B5, BON, B5, BON)
FanLinc will double-beep and the LED will stop blinking
3) Test by sending the X10 address on/off
FanLinc fan will turn on/off
For the light
1) Press & hold FanLinc light set button until it beeps
FanLinc LED will start blinking
2) Send the desired X10 address, plus on, 3 times (e.g. send B5, BON, B5, BON, B5, BON)
FanLinc will double-beep and the LED will stop blinking
3) Test by sending the X10 address on/off
FanLinc light will turn on/off
For other X10 setup instructions visit

Factory Reset

NOTE: All settings and scenes will be erased
1) If possible, remove all links
2) Press & hold FanLinc light set button until it beeps
LED will start blinking
3) Press & hold the FanLinc light set button until it beeps again
LED will start blinking
4) The following three steps must be done quickly to the FanLinc light set button
a. Double-tap
b. Release
c. Press & hold
FanLinc will (beep), LEDs and light will turn off
FanLinc will ((((((beep)))))) for 5 seconds
5) Release after beeping stops
Light LED will turn
Light LED will turn off
FanLinc will (beep)-(beep)
Light LED will turn
Fan's light will turn on

Specifications

General
Page 8 of 12
red if light is off
green
green
http://www.smarthome.com/insteon-x10-programming.html
green
red
green
green
2475F - Rev: 1/19/2012 6:39 PM