Maintenance; Troubleshooting; Error Code List - Furuno WR2120 Operator's Manual

7. MAINTENANCE

7.1. Troubleshooting

STATE
Cannot turn the power on
Thermo electric air conditioner
stopped
- No radar echo indication
- SPU Failure
- System Failure
Error code indication

7.2. Error Code List

Code
E001 Abnormality detected in system [Serial Com (MONI-CON)]
E002 Abnormality detected in system [Serial Com (ANTcontrol)]
E003 Abnormality detected in system [Serial Com (ANTmonitor)]
E004 TCP error
E005 Abnormality detected in system [Detected TCP data missing]
E006 Abnormality detected in system [Serial data (ANTmonitor)]
E013 Abnormality detected in system [Motor Control (ACK Start)]
E014 Abnormality detected in system [Motor Control (ACK Stop)]
E016 Abnormality detected in system [Motor Control (ACK INIT0)]
E017 Abnormality detected in system [Motor Control (ACK INIT1)]
E020 Abnormality detected in system [Motor Control (ACK Run)]
E027 Abnormality detected in system [Motor Control (Wait reply from motor1)]
E028 Abnormality detected in system [Motor Control (Wait reply from motor2)]
W039 Abnormality detected in system [Undefined Error]
E040 SPU abnormality [FPGA module access]
E041 SPU abnormality [IO module setting time out]
E042 SPU abnormality [FPGA setting]
E044 SPU abnormality [FAM_PLL lock time out]
E045 SPU abnormality [FAM_clock formation]
E058 SPU abnormality [FPGA module recognition]
E061 SPU abnormality [Tx setting]
E100 Abnormality detected in system [Serial Com (MONI-CON)]
E101 Abnormality detected in system [Serial Com (ANTcontrol)]
E102 Abnormality detected in system [Serial Com (ANTmonitor)]
E200 RFCONV abnormality [PLL unlock]
E210 HPA abnormality [Outside TX power regulation]
E212 HPA abnormality [Outside temperature regulation]
E312
E313
Drive unit failure detected during zero positioning
E314
E315
CONTENT/PROCEDURE
1. Make sure that the power cable has not loosened.
2. Make sure that the contact of the power cable plug has not stained.
3. Make sure that the power cable has not damaged.
4. Make sure that the circuit breaker in the Junction Unit is "ON".
Please call for service.
1. Stop radar operation to [Stop motor] from RainMap. Restart the
RainMap if not possible to click the [Stop motor] under [Stop radar
operation] menu because of failure.
[Stop motor] will send a reset command to SPU, MONI-CON, motor driver,
and itself to release from error.
2. Use WR_rebooter to reset the radar hardware & software
3. Turn OFF/ON the circuit breaker in SPU (Refer to section 1.3).
1. Restart RainMap and Radar (turn OFF/ON the power).
2. Call for service and tell error code.
Content
70
S2E-17-0208_OM_WR2120_C