Removing And Installing Ac Power Supplies In The Cpx2408 System - Motorola CompactPCI CPX2000 Series Installation And Reference Manual

19. Facing the rear of the chassis, remove the four screws securing the
20. Facing the rear of the chassis, disconnect the power cable
Note
21. Pull these wires and connectors back through the access ports into
22. Remove the power supply:
23. Reverse the above procedure to install a new power supply.

Removing and Installing AC Power Supplies in the CPX2408 System

This section tells you how to remove/install an AC power supply in the
CPX2408 system. If you need information about removing/installing an
AC/DC power supply, refer to the section titled, "Removing and Replacing
AC/DC Power Supplies in the CPX2408 System."
http://www.motorola.com/computer/literature
rear drive bay panel.
connectors from the drives.
Notice where these connectors attach to make sure they are
replaced properly later.
the power supply cage.
a. through the front of the chassis for the CPX2108
b. through the rear of the chassis for the CPX2208
Removing and Installing the Power Supplies
3
3-43