Sealey CAR3000LR Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this
product will, if used according to these instructions, and properly maintained, give you
years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT
IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE
WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. safety
Study, understand and follow all instructions before operating this device.
9
Use only on a hard, level surface.
9
Centre load between the sides of the ramp.
9
Failure to heed these instructions may result in personal injury and/or property damage.
9
No alterations shall be made to this product. Ramps are not to be used to simultaneously raise
9
both ends or one side of the vehicle.
Have a second person watching the ramps as the vehicle is driven on to warn of any unwanted
9
movement.
Be sure the wheels to be driven onto the ramps are positioned straight forward in alignment with
9
the ramps and that the ramps are centred against the tyres.
Ensure that the vehicle wheel rolls as far as the dished portion of the ramp.
9
9
Never accelerate or apply brakes suddenly. Proceed slowly and cautiously. Once the vehicle reaches
the top of the ramps, apply brakes to prevent over travel.
When in place, apply the vehicle handbrake and leave in gear or in 'park' if an automatic.
9
DO NOt exceed the rated capacity of the ramps (1500kg each, 3000kg per pair).
8
DO NOt use this product for any purpose other than that for which it is
8
DO NOt use the ramps if they are in any way
8
2. iNtrODuctiON
Made from durable polypropylene. These ramps are designed to allow jacking access to suitable jacking points
on the vehicle. These ramps are not intended to raise a vehicle enough for under vehicle servicing.
3. specificatiON
odel no:............................................................ CAR3000LR
M
Capacity each/pair: ............................................................ 1.5/3 tonne
Ramp height:............................................................................. 65 mm
Overall dimensions (L x W x H): .............................700 x 200 x 80 mm
OperatiON
© Jack Sealey Limited
car raMps LOW eNtry 1.5tONNe
capacity per raMp 3 tONNe
capacity per pair
MOdEL NO:
M
Original Language Version
car3000Lr
damaged.N
CAR3000LR Issue:2 (1,2,3,4) 24/04/18
designed.i