Table of Contents
Advertisement
I.4 – Armrests adjustment
The adjustment of the length between the handle and the armrest is done thanks to the
screw . 2 keys of 10 are needed.
If the armrest is too wide or too narrow, it's possible to modify it thanks to a thermic scraper.
- Remove the strap (as on picture 2).
- Warm up the plastic part inside at the level of the screws.
- Open or push closer the armrest and keep the desired position until the plastic part is cold.
Attention: The Velcro strap mustn't be warmed or burned during the operation.
Figure 2: Warming up of the armrest
HOW TO ADJUST SUPERLITE
General instructions are the same as for Comfort stabilizers.
II.1 - Adjustment of the ski angle
Stop screw
II.2 - Adjustment of the length of the stabilizer
- Release the string.
- Move the quick clip to the desired height.
- Tight the string.
II.3 - Blocks installation
Put the blocks just under the quick clip. Attention, blocks must be low enough so the ski
doesn't touch the ground when going off the chairlift.
II.4 - Armrests adjustment
Two keys of 11 are needed.
Figure 3: Keeping of the desired shape during cooling of
Screw or unscrew the stop screw
(thanks to a key of 11) to change the
angle. Check that both stabilizers have
the same angle.
Figure 4: Adjustment of the angle of
Superlite stabilizer
the plastic part
®
STABILIZERS
20
Advertisement
Table of Contents
