Page 1
1-11. METHOD OF CONFIRMING THE PHASES OF AP IRIS RING AND AP SENSOR GEAR [About the service of this model] SLT-A58K/A58M/A58Y are commodity that packed the Interchangeable Lens Digital Camera and Interchangeable Lenses. Refer to each following service manual the Interchangeable Lens kit, when you repair.
Page 2
JPEG-compliant (DCF Ver. 2.0, Exif Ver. Maximum dimensions LCD panel 6.7 cm (2.7 type) TFT drive/Clear Photo 2.3, MPF Baseline), RAW (Sony’s exclu- LCD screen Approx. 70 mm × 25 mm × 95 mm sive ARW2.3 format) Total number of dots 460 800 dots (2 7/8 inches ×...
Page 3
ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPO- CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REM- NENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS PLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY DONT SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES...
Page 4
USB Serial No. The set is shipped with a unique ID (USB Serial No.) written in it. This ID has not been written in a new board for service, and therefore it must be entered after the board replacement. Fig. 1 SLT-A58K/A58M/A58Y_L2...
Page 5
7) A file selection screen opens. Select the Destination Data file to be added and click the [Open] button. 4) Download the Destination Data file of the relevant model and unzip the file. 8) When the file has been successfully added, the following window opens. SLT-A58K/A58M/A58Y_L2...
Page 6
(2) Set the AS Slider Unit (863) upwards as shown in figure, and put it on a stable place. (3) Select “Slider Unit Check” of the adjustment software, and then confirm the movement to the directions of Pitch and Yaw, and if an error occurs, replace it with the component part corresponding to the movement. SLT-A58K/A58M/A58Y_L2...
Page 7
G G-15 Ball Bearing G G-15 (5) Remove the AS Unit Holder Ball. AS Slider B Assy T AS Unit Holder Ball (11) Remove the three Ball Bearings. (6) Remove the two Ball Bearings. Ball Bearing Ball Bearings Ball Bearing SLT-A58K/A58M/A58Y_L2...
Page 8
(3) Insert the pin (approx. 1mm in diameter) through the hole of front frame and drop the tip of pin in the cut portion of AP Sensor Gear AS Holder Actuator Assy to fix the AP Sensor Gear. Hole of front frame Cut portion of AP Sensor Gear SLT-A58K/A58M/A58Y_L2...
Page 9
This line orients toward the be in between two parallel lines. center of front frame. This line is parallel and contacts the right side of projection. The gap exists. AP Torque Limiter Assy (T) Turn the AP Sensor Gear 3 rotations SLT-A58K/A58M/A58Y_L2 1-6E...
Page 10
• AFP-007 Flexible Board • AP-037 Flexible Board • BL-038 Flexible Board • SLK-009 Flexible Board 2 Front Cover Section 7 Jack Holde Block Assy • RM-100 Flexible Board 6 BD Bottom Frame Assy Link DISCHARGING OF THE CHARGING CAPACITOR ACCESSORIES ASSEMBLY SLT-A58K/A58M/A58Y_L2...
Page 11
1 kΩ /1 W (1-215-869-11). Wrap insulating tape fully around the leads of the resistor to prevent electrical shock. 1 kΩ/1 W 1 kΩ/1 W Wrap insulating tape. Wrap insulating tape. AM-1001 Board SUBSIDIARY MATERIALS G: Grease G-15 (J-6082-619-A) G-85 (J-6082-626-A) G-116 (J-6082-628-A) SLT-A58K/A58M/A58Y_L2...
Page 12
Part No. Description 4-460-617-01 VM EYE CUP (876) 2-635-562-31 SCREW (M1.7) 4-460-613-01 BD AM ST CARE SHEET (876) 3-080-204-21 SCREW, TAPPING, P2 4-154-680-01 CV DIOPTER ADJUST DIAL (857) #112 2-178-410-11 TITE (UB TITE) 1.4 4-460-615-01 CV JACK LID (876) SLT-A58K/A58M/A58Y_L2...
Page 13
3-274-513-01 TAPE (ASCD) 4-460-614-01 CV DC LID (876) X-2586-489-1 CV FRONT COVER ASSY(876) 2-635-562-31 SCREW (M1.7) 1-492-092-11 SWITCH BLOCK, CONTROL (TK87600) 3-080-204-01 SCREW, TAPPING, P2 3-080-204-21 SCREW, TAPPING, P2 4-449-470-01 CV MODEL NAME PLATE (876) #140 2-635-562-01 SCREW (M1.7) SLT-A58K/A58M/A58Y_L2...
Page 14
For the part of 101 : BD TOP FRAME SHEET (876) cut NON WO- 4-460-622-01 BD LIGHT GUARD SHEET (876) 3-080-204-21 SCREW, TAPPING, P2 VEN (T0.25) (3-076-631-01) into the desired length and use it. #109 2-515-483-21 SCREW (M1.7), LOCK ACE, P2 A-1935-877-A AM-1001 BOARD, COMPLETE (SERVICE) X-2582-398-1 BD BOTTOM FRAME ASSY SLT-A58K/A58M/A58Y_L2...
Page 15
JACK, DC X-2586-484-1 BD JACK HOLDER ASSY (876) SP901 1-826-403-61 LOUDSPEAKER (1.0CM) 1-487-960-23 SHUTTER UNIT (AFE-3032) (Note 1) A-1869-165-A ALX-8631 (Note 2) 3-080-204-21 SCREW, TAPPING, P2 (including AF-131 flexible complete board) #207 4-191-605-01 S ADJUSTMENT SCREW 2-693-420-01 SP, S ADJUSTMENT SLT-A58K/A58M/A58Y_L2...
Page 20
TERMINAL BOARD, BATTERY X-2586-486-1 BD BATTERY HOLDER ASSY(876) C901 1-116-522-11 CAP, ELECT 180uF 330V 4-293-657-01 CV MEDIA LID COVER SHAFT 4-460-629-01 CV MEDIA COVER (876) 2-635-562-31 SCREW (M1.7) 4-293-658-01 CV MEDIA LID COVER SP 3-080-204-01 SCREW, TAPPING, P2 SLT-A58K/A58M/A58Y_L2 2-11...
Page 21
3-080-204-11 SCREW, TAPPING, P2 (including BL-038 flexible board) #164 3-268-954-11 SCREW, AF BASE PLATE STOPPER 2-689-314-01 ROLLER (B), RING #165 2-695-434-31 SCREW (T1.7), HEAD PAN TAPPING 3-268-951-01 SHAFT, RING ROLLER (C) #295 2-695-575-21 SCREW (T2), +P1 PAN TAPPNG SLT-A58K/A58M/A58Y_L2 2-12...
Page 22
MB LENS LOCK BASE PLATE 4-292-475-01 MB SHUTTER CHARGE LEVER 4-292-585-01 MB AF/MF SELECTION LEVER 4-292-476-01 MB SHUTTER CHARGE LEVER SP 4-292-473-01 MB DECELERATION GEAR 1 3-080-204-11 SCREW, TAPPING, P2 4-292-474-01 MB DECELERATION GEAR 2 #241 3-703-816-46 SCREW (M1.4X2.5), SPECIAL HEAD SLT-A58K/A58M/A58Y_L2 2-13...
Page 23
4-459-706-31 α Handbook (PERSIAN) (Note 1) 4-460-617-01 Eyepiece cup * 915 4-459-706-41 α Handbook (KOREAN) (Note 1) X-2582-535-2 Front lens cap (SLT-A58K/SLT-A58Y) * 915 4-459-706-51 α Handbook (POLISH) (Note 1) X-2582-781-1 Front lens cap (SLT-A58M) 2-683-615-01 Rear lens cap (SLT-A58M/SLT-A58Y)
Page 24
Cushion MB Shutter Charge Ring Roller (C) Camgear Assy Ring Roller Shaft (C) Ring Roller (C) MB Deceleration MB Deceleration GG-85 Gear 2 Gear 1 Ring Roller Shaft (C) Ring Roller (C) AP Iris Ring Ring Roller Shaft (C) SLT-A58K/A58M/A58Y_L2...
Page 25
* Do not slide from right to left or up and down while dabbing. EE3310 4. Wait until the tip will be dried completely. Cleaning Jig (J-6082-635-A) 1 Souse the cleaning cloth in ethyl alcohol. 2 The dry cleaning cloth. SLT-A58K/A58M/A58Y_L2 3-2E...
Need help?
Do you have a question about the SLT-A58K and is the answer not in the manual?
Questions and answers