Philips Sonicare 2 Series Manual page 14

ENGLISH
14
2 Insert a small standard screwdriver into the bottom of the handle
and turn it counter-clockwise to remove the screw. Pull the end
cap off of the handle (Fig. 12).
3 Insert the screwdriver between the handle and the internal frame.
Tilt the screwdriver to loosen the handle (Fig. 13).
4 Remove the internal frame from the handle. (Fig. 14)
5 Remove the rubbers that are on top and below the battery
(Fig. 15).
6 Insert the screwdriver between the battery and the frame. Tilt the
screwdriver to pop the battery out of the frame (Fig. 16).
7 Place some tape over the ends of the battery to avoid any
short-circuiting due to residual energy in the battery (Fig. 17).
Guarantee and support
If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.
Guarantee restrictions
The terms of the international guarantee do not cover the following:
- Brush heads.
- Damage caused by use of unauthorised replacement parts.
-
repair.
-
discolouration or fading.
Damage caused by misuse, abuse, neglect, alterations or unauthorised
Normal wear and tear, including chips, scratches, abrasions,