Items Supplied; Before Using For The First Time - Silvercrest SDMF 1100 A1 Operating Instructions Manual

__296303_Dampfbürste_mit_Fuß_B6.book Seite 7 Dienstag, 24. Oktober 2017 1:16 13
DANGER! Risk of injury
through burning
Do not touch the hot surfaces of the de-
vice.
Allow the device to cool down com-
pletely before you clean it or put it
away.
Warning, risk of burns from steam and
splashes of hot water when using the
steam jet button! when using the steam
jet, always point the steam unit towards
the item of laundry.
The steam unit becomes very hot during
operation. Only touch the handle and
control elements of the device during
operation.
Never smooth clothes while they are be-
ing worn.
Only transport the device when it has
cooled down.
Wait for the device to cool down before
cleaning.
Please wait until the device has cooled
down before you attach and remove the
clothes brush.
Allow items of clothing to cool down on
a clothes hanger before you wear them.
WARNING! Risk of material
damage
Only use the original accessories.
Do not use any sharp or abrasive clean-
ing aids.
Do not use the device on e.g. zips, met-
al buttons or applications that could
damage the steam unit.
Never fill the water tank with chemical
substances, cleaning agents – with the
exception of descaling agents – or other
liquids. Do not use chemically deminer-
alised water. This may result in irrepara-
ble damage to the device.

4. Items supplied

1 steam brush
1 clothes brush 2
1 copy of the user instructions
Please observe the illustrations on the fold-
out page.
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
3. Remove any stickers or films from the
device.
5. Before using for the
first time
NOTE: you may notice an odour when us-
ing for the first time. This is a result of the
manufacturing process and is not a defect
with the device. Ensure adequate ventila-
tion.
1. Ensure that you have pulled out the
mains plug 10.
2. Figure A: press both release buttons 5
of the water tank 8 and pull the tank
straight outwards.
3. Open the lid 7 over the filling opening 6.
4. Fill the water tank 8 to about halfway
and then close the lid 7.
5. Place the water tank 8 onto the device.
The water tank must audibly click into
place with the release mechanism 5.
6. Insert the mains plug 10 into an
earthed wall socket corresponding to
the technical data.
The control light 1 flashes.
7. When the device is ready to steam, the
control light 1 will be lit continuously.
7
GB