Error Messages - roco multiMAUS Manual

E M
RROR ESSAGES
ERR 1: Not compatible for programming.
ERR 2: No confirmation was received from the decoder when programming / reading.
Check whether the connection to the decoder is faulty due to dirt on the tracks or wheel con-
tacts. Replace the locomotive on the track.
Check whether there is a capacitor somewhere in the track system.
ERR 3: A short circuit has occurred whilst programming / reading.
Check whether the locomotive is placed correctly on the track and make sure the wiring is not
faulty.
The locomotive may be standing on a polarized frog (the turnout setting however does not
match the route of the locomotive).
The decoder may not be connected properly on a converted locomotive.
ERR 4: Not possible in "POM" mode.
This error occurs if the multiMAUS is changed over to "POM" mode
intending to program CV1 (locomotive address). Program CV1 on a separate section of pro-
gramming track in "CV mode"
ERR 5: Programming mode is active.
ERR 6: Not available because track voltage is switched off (occurs in "POM" mode).
ERR 7: The library is empty (menu "LOCO" – "DELETE").
ERR 8: The library is full (e.g. when entering a new locomotive).
You can save a maximum of 64 locomotives in the library. Control the locomotive using locomo-
tive address mode or use an additional multiMAUS.
ERR 9: The locomotive was not found (menu "LOCO" – "SEARCH").
The locomotive address has not been created in the library.
ERR 10: A locomotive with the same address already exists (when entering a new locomotive in the
locomotive library).
ERR 11: The locomotive address is outside the valid value range.
You are using a Lokmaus 2, for instance, as the master and it only supports 99 locomotive ad-
dresses.
ERR 12: X-PressNet is not compatible with X-Bus.
Only X-PressNet versions 3.0 and above are compatible with the multiMAUS.
ERR 13: No X-PressNet master was found.
There is a problem with the device connected to the master output. Unplug the device and re-
connect it. If this does not solve the problem, check the X-Bus address.
ERR 14: The calibration values are invalid.
The controller needs to be recalibrated. See
ERR 90 and above:
Your multiMAUS is unfortunately in need of service by the ROCO service department.
(see page 49).
page 52, 3.5.6.
(page 49) when you are
��
59