Advertisement
R
e
a
d
R
e
a
d
The information contained here-in is the property of MEI and is not to be disclosed or used
without the prior written permission of MEI. This copyright extends to all the media in which
this information may be preserved including magnetic storage, punched card, paper tape,
computer printout or visual display.
Copyright 2007 MEI
E
a
E
a
e
r
I
n
s
t
a
l
l
e
r
I
n
s
t
a
l
l
S
p
e
c
i
f
S
p
e
c
i
f
COPYRIGHT © 2007 MEI
Installation Guide & Specifications
s
i
t
r
a
x
S
s
i
t
r
a
x
S
a
t
i
o
n
G
u
a
t
i
o
n
G
u
i
c
a
t
i
o
n
i
c
a
t
i
o
n
C
C
i
d
e
&
i
d
e
&
Page 1 of 6
20105-00289XXXX-IG G1
Advertisement
Table of Contents
Summary of Contents for MEI Easitrax SC
- Page 1 & COPYRIGHT © 2007 MEI The information contained here-in is the property of MEI and is not to be disclosed or used without the prior written permission of MEI. This copyright extends to all the media in which this information may be preserved including magnetic storage, punched card, paper tape, computer printout or visual display.
- Page 2 MEI reserves the right to change the market requirement specifications at any time. While every effort has been made to ensure that the information in this publication is accurate, MEI disclaims any liability for any direct or indirect losses (howsoever caused) arising out of use or reliance on this information.
- Page 3 The document below describes the installation and setup for the Easitrax SC Reader base which is used with the MEI Easitrax SC Cashbox asset tracking system. The Easitrax SC Reader base is typically used in a casino soft drop accounting area in concert with a client personal computer running software to interrogate the reader base for cashbox cassettes.
- Page 4 Ensure that the intended client device to be used with the Reader base has had a version of the MEI reader software installed. This software allows the Reader base to be recognized as a new USB device when the installation is completed and is available from either MEI or from your currency counting equipment provider.
- Page 5 Once the reader base cable is fully installed, you may power on the personal computer and allow the computer to boot up. The blue front panel LED on the Easitrax SC Reader base should light and go through a brief power on test. Following this test only the blue power on indicator LED should be illuminated.
- Page 6 PC. Power down and repower the client PC and ensure that the reader base is recognized and that the power on indicator blue led comes on. If you are still having problems, please contact MEI Customer Technical support at 1-800-523-5146 or visit www.meigroup.com Copyright 2007 MEI Page 6 of 6 Installation Guide &...
Need help?
Do you have a question about the Easitrax SC and is the answer not in the manual?
Questions and answers