Little Tikes My First Helicopter Quick Manual

SKU: 655517
A. 1 Helicopter C. Top Rotor Blade G. Screwdriver
B. 1 Remote Control D. Bottom Rotor Blade H. 5 Screws (One screw will be attached
E. 2 Wings to the stem of the top rotor blade.)
I. 2 Screws for the Wings
F. Connector
C.
H.
A.
B.
E.
Illustrations are for reference only. Styles may vary from actual contents.
CAUTION: KEEP FINGERS AWAY
FROM SPINNING PROPELLERS
QUICK START
NOTE: Please read all instructions before use and keep this manual for future reference.
1) Install 6 "AA" (LR6) batteries in the remote control.
2) Charge the helicopter's battery for 30-40 minutes.
3) Turn on the helicopter.
4) Turn on the remote control.
5) Use the buttons on the remote control to y your helicopter in an open, indoor area.
STABILIZER
PROTECTIVE RINGS
STABILIZER LINKAGE
SKID
TAKE OFF
LEFT TURN
LANDING
CHARGING PLUG
AGES 3+ YEARS
Before beginning, an adult must install fresh alkaline batteries. Here's how:
1. Using a Phillips screwdriver (not included), remove the screw and battery compartment cover
located on the back of the remote.
ADULT SUPERVISION, ASSEMBLY,
2. Install six (6) fresh 1.5V AA (LR6) alkaline batteries (not included) making sure the (+) and (-)
AND BATTERY INSTALLATION REQUIRED
ends face the proper direction as indicated inside the battery compartment.
3. Replace the compartment cover and tighten the screw.
D.
G.
F.
H. x4 I. x2
1
ROTOR BLADES
Take out the charging cable from the
bottom of the remote.
POWER
SWITCH
SENSOR
CHARGING
SOCKET
POWER INDICATOR
RIGHT TURN
EMERGENCY
STOP
POWER SWITCH
BATTERY INSTALLATION
6 x AA Batteries
CHARGING THE HELICOPTER
2
Turn the helicopter OFF (O/ ) and insert the cable
into the charging station under the helicopter.
I = ON
O = OFF
3
O
Turn ON (I / ) the remote control. The light on the
remote control will turn red and blink. Once it has
nished charging, the light on the remote will turn
green. Unplug the charging cable and replace the
cord in the unit.
FLYING LESSONS
HELPFUL FLYING TIPS
• If the helicopter crashes, switch the remote control and the helicopter to the OFF positions. Carefully check
that no damage was done to the helicopter in the crash before turning the unit on again.
• For best results, use the helicopter away from bright lights.
• Do not cover the sensor on the helicopter.
• Keep the remote control within 15 feet (5 meters) of the helicopter to avoid loss of reception.
EMERGENCY STOP:
If the helicopter crashes, press the stop button to
stop the propellers. Turn the helicopter and
remote control o . Examine the helicopter for any
damage before switching it on and ying again.
1
Turn the helicopter ON (I). The power LEDs on the headlights will ash.
2
O
O
Place the helicopter on a at surface and stand three feet away.
3
O
Turn the remote control ON (I/ ). The power indicator will light up.
O
3 FEET
O