Parksense Warning Display; Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System; Cleaning The Parksense System - Dodge CHALLENGER 2021 Owner's Manual

118 STARTING AND OPERATING
P S W D
ARK ENSE ARNING ISPLAY
The ParkSense Warning screen will only be
displayed if Sound and Display is selected from
within the Uconnect system Ú page 133.
The ParkSense Warning screen is located within
the instrument cluster display Ú page 69. It
provides visual warnings to indicate the
distance between the rear fascia/bumper and
the detected obstacle.
E A D
NABLING ND ISABLING
ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
When the ParkSense switch is pushed
to disable the system, the instrument
cluster will display the "ParkSense
Off" message for approximately five
seconds. When the gear selector is moved to
REVERSE and the system is disabled, the
instrument cluster display will display the
"ParkSense Off" message for as long as the
vehicle is in REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed, and the system requires service, the
ParkSense switch LED will blink momentarily,
and then the LED will be on.
S T
ERVICE
A S
SSIST YSTEM
During vehicle start up, when the ParkSense
P S
ARK ENSE
Rear Park Assist System has detected a faulted
condition, the instrument cluster will actuate a
single chime, once per ignition cycle and it will
display the "PARKSENSE UNAVAILABLE WIPE
REAR SENSORS" or "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message
for five seconds.
When the gear selector is moved to REVERSE
and the system has detected a faulted
condition, the instrument cluster display will
display the "PARKSENSE UNAVAILABLE WIPE
REAR SENSORS" or "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message
for as long as the vehicle is in REVERSE. Under
this condition, ParkSense will not operate.
P S R P
HE ARK ENSE EAR ARK
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" appears in the instrument cluster
display, make sure the outer surface and the
inside of the rear fascia/bumper is clean and
clear of snow, ice, mud, dirt or other
obstruction, and then cycle the ignition. If the
message continues to appear see an
authorized dealer.
If "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" appears in the instrument cluster
display, see an authorized dealer.
C T P S
LEANING HE ARK ENSE
Clean the Rear Park Assist sensors with water,
car wash soap and a soft cloth. Do not use
rough or hard cloths. In washing stations, clean
sensors quickly keeping the vapor jet/high
pressure washing nozzles at least 4 inches
(10 cm) from the sensors. Do not scratch or
poke the sensors. Otherwise, you could damage
the sensors.
S
YSTEM