Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for H-KING Vought f4U Corsair
Summary of Contents for H-KING Vought f4U Corsair
- Page 1 W I TH O RX S T AB I L I Z ER INSTRUCTION MANUAL...
- Page 2 This plane is guaranteed to be free from defects in material and workmanship at the date of purchase. It does not cover any damage caused by use or modification. The warranty does not extend beyond the product itself and is limited only to the original cost. By the act of controlling this product, the user accepts all resulting liability for damage caused by the final product.
- Page 3 SAFETY INSTRUCTIONS Please read this manual carefully and follow the instructions before you use this product. This airplane is not a toy but due to having installed the ORX stabilization system it is suitable for pilots with low experience. However, if you do fall into this category then we recommend you enlist the help of an experienced RIC pilot to give you a hand with the initial flights.
- Page 4 Kit content PNF Version Fuselage, Main Wing, Horizontal Stabilizer, Main Landing Gear, Propeller, Missile set, Drop tanks and an accessory bag. Specifications: 750mm ★Wingspan 610mm ★Length 420g ★Weight ≥450g ★Thrust ★Flying time ≥5 min ★Radio system 5 channel & up (Recommended) ★Motor 2408-1200KV 800-850mAh 3S (Recommended)
- Page 5 Assembly Instruction: 1. Assembly of the main landing gear Install the landing gear into the slots which are located on the underside of the main wing. Note: Both wheels face each other. Secure each one using 2 x 8mm self-tapping screws. 2.
- Page 6 4. Attaching the fin and rudder assembly to the fuselage. Before you insert the fin post into the slot in the rear of the fuselage, ensure the tail wheel is aligned as shown in the picture below. Apply some glue to the base of the fin and the mounting tab and insert it into the slot. At the same time, the U-shaped wire also needs to be aligned straight before you insert and glue the fin/rudder assembly into place.
- Page 7 7. Attaching the drop tank to the main wing Apply glue to the drop tank and glue it into the indent which is located beneath the wing as shown. 8. Your F4U Corsair is complete Check the center of gravity and make sure it is within the range shown below. For initial flights it is best to balance the model on or near the 40mm mark to make the flying characteristics more docile.
- Page 8 ORX flight stabilisation system Features: • Integrated with a 32bit MCU and a 6 axis digital gyro for ultra fast flight control response • The ORX stabilization device is tuned specifically to a particular model for the best flying performance. •...
- Page 9 To taxi back keep full up elevator in and gently use the throttle and the rudder to steer the model back. We hope you enjoy flying your H-KING F4U Corsair and if you haven't already tried out the others in our range then we recommend you visit our website at www.hobbyking.com...
- Page 10 Accessories Turnigy nano-tech 850mah 3S Turnigy 800mAh 3S 25~40C Lipo Pack 20C Lipo Pack SKU: N850.3S.25 SKU: T800.3S.20 ZIPPY Flightmax 800mAh 3S1P Turnigy Nano-Tech 850mAh 3S 20C Lipo Pack 30C Lipo Pack SKU: Z8003S20C SKU: 9210000273-0...
- Page 11 Made in China...
Need help?
Do you have a question about the Vought f4U Corsair and is the answer not in the manual?
Questions and answers