Blade Guide Horizontal Tilt Adjustment - Wood-mizer LT35 Safety, Setup, Operation & Maintenance Manual

Blade Guide Horizontal Tilt Adjustment

If the blade guides are tilted in the wrong direction horizontally, the back of the blade may
contact the flange as the roller is spinning down, causing it to push the blade away from
the guide roller.
1. Remove the blade guide alignment tool from the blade and adjust the blade guide arm
halfway in.
2. Remove the clip from the blade guide alignment tool. Place the tool against the face of
the outer blade guide roller.
See Figure 7-27.
3H0802-5B
3. Measure between the back edge of the blade and the tool at the end closest to the inner
blade guide ("B").
4. Measure between the back edge of the blade and the other end of the tool ("A").
The roller should be tilted slightly to the left ('A' 1/8" [3 mm] less than 'B' ±1/8" [3 mm]).
See Figure 7-28. Loosen the jam nuts on the horizontal tilt adjustment screws. To tilt the
roller left, loosen the right screw and tighten left screw. To tilt the roller right, loosen the
Sawmill Alignment
Blade Guide Horizontal Tilt Adjustment
A
Blade Guide
Alignment Tool
WMdoc072619
Sawmill Alignment
B
FIG. 7-27
7
7-26