Advertisement

Quick Links

π
H-8649
PORTABLE AIR
CONDITIONER
Exhaust Hose x 1
Window Slider Kit x 1
Remote Control x 1
NOTE: Check that all accessories are included in the package
and refer to installation instructions for usage.
WARNING! Read this section before attempting
to operate air conditioner. Unit must be upright
one hour prior to operating.
The power cord contains a current device that senses
damage to the cord. To test your power cord, do the
following:
1.
Plug in the air conditioner.
2. The power cord will have two buttons on the plug
head. Press the TEST button. You will notice a click as
the RESET button pops out.
3. Press the RESET button. Again, you will notice a click
as the button engages. (See Figure 1)
4. The power cord is now supplying electricity to the unit.
PAGE 1 OF 10
1-800-295-5510
uline.com
ACCESSORIES INCLUDED
Unit/Exhaust Adapter A x 1
1/2" Screw x 4
Sash Lock x 1
SAFETY
Window/Exhaust Adapter B x 1
3/4" Screw x 2
Battery (For Remote Control) x 2
NOTE: Do not use this device to turn the unit
on or off. Always make sure the RESET button
is pushed in for correct operation. The power
cord must be replaced if it fails to reset when
either the TEST button is pushed or if it cannot
be reset. If power supply cord is damaged,
it cannot be repaired. It must be replaced.
Contact Uline Customer Service for assistance
at 1-800-295-5510.
Figure 1
Foam Seal x 3
1/2" Hex Head
Cap Screw x 2
0320 IH-8649

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the H-8649 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for U-Line H-8649

  • Page 1 π H-8649 1-800-295-5510 uline.com PORTABLE AIR CONDITIONER ACCESSORIES INCLUDED Window/Exhaust Adapter B x 1 Foam Seal x 3 Exhaust Hose x 1 Unit/Exhaust Adapter A x 1 Window Slider Kit x 1 1/2" Screw x 4 3/4" Screw x 2 1/2"...
  • Page 2: Normal Sounds

    NORMAL SOUNDS Sound of Rushing Air At the front of the unit, the sound of rushing air being moved by the fan may be heard. Gurgle/Hiss “Gurgling or hissing” noise may be heard due to refrigerant passing through evaporator during normal operation.
  • Page 3: Installation

    INSTALLATION EXHAUSTING HOT AIR 5. Affix adapter B into the window slider kit and seal. (See Figures 6 and 7) In cooling mode, the appliance must be placed close Vertical to a window or opening so that the warm exhaust air Window can be ducted outside.
  • Page 4: Installation In A Double Hung Sash Window

    INSTALLATION CONTINUED INSTALLATION IN A DOUBLE HUNG 3. Close the lower sash securely against the window slider kit. (See Figure 12) SASH WINDOW 4. Drive two 1/2" screws to secure the window slider kit 1. Cut the adhesive-type foam seals to the proper to the lower sash.
  • Page 5: Installation In A Sliding Sash Window

    INSTALLATION CONTINUED INSTALLATION IN A SLIDING SASH WINDOW 3. Close the sliding sash securely against the window slider kit. (See Figure 18) 1. Cut the adhesive-type foam seals to the proper 4. Secure the window slider kit to the window sill. lengths and attach them to the window frame.
  • Page 6: Air Conditioner Features

    AIR CONDITIONER FEATURES CONTROL PANEL Display Temperature/Timer °C °F Swing Activates Sleep Mode Sets Fan Filter Turns Unit Mode Timer Mode Selection Speed Reset on or off Adjusts Indicator Temperature or Timer REMOTE CONTROL Remote Control Screen Temp/Timer Setting Button On/Off Button Mode Button Fan Speed Button...
  • Page 7: Operation

    OPERATION NOTE: The following instructions explain the control panel, and they can be used for the remote control also. COOLING MODE TIMER OPERATION In this mode, the exhaust adapter hose must be used: You can set both delay stop and delay start while unit is in ON or OFF position.
  • Page 8: Swing Operation

    OPERATION CONTINUED SWING OPERATION DRAINAGE When you turn on the unit, the louver will swing and stop During the dehumidifying mode, you will need a at a certain angle. You can press the SWING button garden hose (sold separately) to drain the condensate to let the louver swing automatically.
  • Page 9: Additional Information

    OPERATION CONTINUED ADDITIONAL INFORMATION • The control panel is capable of displaying temperature in Fahrenheit or Celsius. To convert from • The "cool" circuit has an automatic three minute one to the other and back, press and hold the "Temp" Up time-delayed start if the unit is turned off and on ( ) and Down ( ) buttons together for three seconds.
  • Page 10: Troubleshooting

    TROUBLESHOOTING OPERATING ISSUE CAUSES RECOMMENDATIONS Air conditioner will not operate. Wall plug disconnected. Push plug firmly into wall outlet. Plug current device tripped. Press the RESET button. House fuse blown or circuit breaker tripped. Replace fuse with time-delay type or reset circuit breaker.

Table of Contents