Status Commands - JDS Uniphase HA9 Series User Manual

:OUTPut[:STATe]?
Syntax :OUTPut[:STATe]?
Function Returns the state of the beam block: 1 if the beam block is out of the beam and
0 if the beam block is in the beam.
Example
:OUTP ON;STAT? returns 1.
:OUTP OFF;STAT? returns 0.
:OUTPut[:STATe]:APOWeron
Syntax :OUTPut[:STATe]:APOWeron <space> <boolean | DIS | LAST>
Function Sets the state of the beam block at power-on: DIS, OFF, or 0 leaves the beam
block in the beam, and 1, ON, or LAST sets the beam block state at power-on to
the same state that the beam block was in at power-off.
Example :OUTP:APOW LAST when the attenuator is powered on, restores the beam
block state to the same state it was in when the attenuator was powered off.
:OUTP:STAT:APOW DIS leaves the beam block in the beam at power-on.
:OUTPut[:STATe]:APOWeron?
Syntax :OUTPut[:STATe]:APOWeron?
Function Returns the state of the beam block at power-on: 1 if the beam block is set to the
same state that it was in at power-off and 0 if the beam block state is in the
beam.
Example
:OUTP:APOW 1;:OUTP:APOW? returns 1.

Status Commands

:STATus:OPERation:CONDition?
Syntax :STATus:OPERation:CONDition?
Function Returns the contents of the operation condition register as an integer that, when
converted to a binary number, represents the bit values of the register.
The attenuator only uses bit 1 of the operation condition register. Bit 1, the
settling bit, is set when the attenuator is in the process of adjusting the actual
attenuation.
Example :STAT:OPER:COND?
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Programming Guide – 76