Sealey VS2059.V3 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. safety
WarninG! ensure Health and Safety, local authority and general workshop
‰
practice regulations are adhered to when using tools.
WarninG! Always use caution when working around fuel systems.
‰
The fuel in the fuel rail may be pressurised even if the engine is not running.
These instructions are provided as a guide only. Always refer to the vehicle
manufacturer's service instructions, or a proprietarymanual, to establish the
current procedure and data, also any warnings or cautions particular to the
vehicle.
do not use the set if any parts are missing or damaged.
8
do not use this tool for any purpose other than that for which it is designed.
8
Switch off vehicle's ignition and disconnect the battery before commencing
9
work under the bonnet.
You must follow the vehicle's service manual cautions when working around the air bag system. If the cautions are not followed the air
9
bag may deploy unexpectedly even after the ignition is turned 'oFF', resulting
in personal injury.
do not lay tools on the vehicle's battery. This may short the terminals
8
together, causing harm to yourself, the tools, or the battery.
operate in a well ventilated area. do not inhale fuel vapours.
9
Wear approved eye protection.
9
Wear suitable clothing to avoid snagging. do not wear jewellery and tie
9
back long hair.
Keep children and other unauthorised persons away from the working area.
9
Keep yourself, tools, and test equipment away from hot engine parts.
9
Always keep a fire extinguisher that is suitable for fuel/electrical/chemical
9
fires close by,
do not smoke or have open flames near vehicle.
8
Always relieve fuel pressure before disconnecting fuel lines from injectors.
9
Use a cloth to cover fuel line fittings when connecting or disconnecting fuel
9
lines. Avoid contact with fuel.
Clean up all fuel spills immediately and dispose of all used cloths properly.
9
maintain the tool components in good and clean condition for best and safest
9
performance.
When work on the vehicle is finished, ensure all connections on vehicle are
9
restored, and that there are no tools left in the engine bay.
Replace tools in the carrying case and store in a safe, dry, childproof location.
9
2. introduction
Suitable for the fast and safe removal of Bosch, delphi, denso and Siemens
diesel injectors. Set includes keys and deep open profile sockets, used to
dismantle injectors, plus adaptors for attaching the slide hammer securely to
the body of the injector. Ball joint allows hammer to be used in confined areas.
3. contents fig.1.
item description
1 Sliding Hammer
2 Handle
3 Shaft
4 Ball Joint Adaptor (3 piece)
5 Adaptors - (5 Pieces - 4 internal thread, 1 external thread)
6 external Adaptor - (3 piece)
7 Security Hex Key - ½"sq. drive
8 Sockets - (4 pieces - m25, m27, m29, m30 - ½"sq. drive)
© Jack Sealey limited
diesel injector puller set - 14 piece
model no:
Wear protective
gloves
Original Language Version
Vs2059.V3
fig.1
fig.2
VS2059.V3 | Issue 2 (F) 21/03/18