Configuring The Plc In Tia Portal - SEW-Eurodrive MOVI-C UHX45A Series Manual

5.4.3

Configuring the PLC in TIA Portal

The properties and parameters of a device can be edited in the hardware and network
editor in the inspector window (lower section of the editor).
Proceed as follows:
ü You have created a new TIA Portal project.
1. Enter the IP address parameters of the PLC in the "Ethernet addresses" tab. Note
ð In this example, the IP address of the PLC is: 192.168.10.39
that the IP address of the PLC is different from the IP address of all other network
stations and thus is unique. The network address (here the first 3 address blocks)
for all network stations must be identical and the station address (here the last ad-
dress block) of the PLC must be different from the network address of all other sta-
tions.
®
Manual – MOVI-C CONTROLLER advanced with PROFINET IO Fieldbus Interface
Startup with PROFINET IO
Configuration of the fieldbus stations
9007216444268555
5
59