Advertisement
14. Connect FTDI Programmer to RCTX then connect USB to computer.
15. Click Verify then wait until done compiling.
16. Click Upload then wait until done uploading.
17. Disconnect USB from computer then disconnect FTDI Programmer from RCTX.
18. Upload complete.
Settings
1. Connect FTDI Programmer to RCTX then connect USB to computer.
2. Double click openLRS.ino file.
3. Click Tools>Board>Arduino Pro or Pro Mini(5V, 16 MHz) w/ATmega328.
4. Click Tools>Serial Port then select
correct
port.
5. Click Serial Monitor.
6. Select Newline and 115200 baud.
7. Close Serial Monitor.
8. Press and hold FAIL SAFE button on RCTX.
9. Click Serial Monitor.
10. Loaded settings from EEPROM will appear.
11. Release FAIL SAFE button on RCTX.
12. Entering binding mode will appear.
13. Click Send.
14. Menu will appear.
15. Adjust as necessary.
Bind
1. Press and hold FAIL SAFE on RCTX.
2. Power on RCTX.
3. WARNING LED on RCTX will turn on once then RCTX will beep once.
4. Release FAIL SAFE button on RCTX.
5. RCTX will beep repeatedly.
6. Power on RCRX.
7. LED 2 on RCRX will turn on briefly then both LED 1 and LED 2 will turn on.
8. Power off RCRX.
9. Power off RCTX.
10. Bind complete.
2
I2FPV
Advertisement
