HM196_EN.book Page 28 Tuesday, May 30, 2006 2:18 PM
Setting the time and date
Note: If you already set up the TV Guide On Screen
the time and date were set automatically and you can skip this
step.
To set the time and date:
Press Y and open the Setup menu.
1
Highlight Installation and press T.
2
3
(A new set of Installation menu icons will appear, as
shown below.) Open the Time And Date menu,
highlight Start Setup, and press T.
Time And Date
Start Setup
Navigate
ENTER
If you have not set up the TV Guide On Screen
the following screen will appear. To set the time, highlight
TV Guide On Screen
™
On Screen
setup sequence will start, and the time and
date will be set automatically.
Time And Date
Your TV Guide On Screen system can provide accurate
time and date information.
It is recommended you set up TV Guide On Screen
first and use it to obtain the time and date.
Manual
TV Guide On Screen
If you have already set up the TV Guide On Screen
system, or if you have not set up the time, the Time and
Date setting screen will appear and you will need to
manually set the time and date.
Time And Date
Date (MM/DD/YY)
Time (HH:MM)
In the event that your TV Guide On Screen system
has acquired time, the television will use network
acquired time rather than manually enterred time.
Cancel
Note:
• If you highlight TV Guide On Screen
time and date through the TV Guide On Screen
a power outage occurs, the time and date will be updated
automatically when the power is restored.
• If you highlight Manual (above) to set the time and date
manually and a power outage occurs, you will lose the time
and date settings when the power is restored.
• If you manually set the time and date and then perform
TV Guide On Screen
™
setup, the manual time and date
settings will be overridden by the TV Guide On Screen
settings.
28
Chapter 4: Setting up your TV
™
system,
Select
CH RTN
Back
EXIT
Exit
™
system,
and press T. The TV Guide
™
Cancel
™
0 6 3 0 / 0 5
/
1 1 1 1 AM
:
Done
™
(above) to set the
™
system and
™
Setting the ColorStream
audio mode
To set the ColorStream HD audio mode:
Press Y and open the Setup menu.
1
2
Highlight ColorStream HD1 Audio (or
ColorStream HD 2 Audio) and press c.
Press B or b to select Yes or No and press T to display
3
the information.
Setup
Installation
Sleep Timer
On/Off Timer
ColorStream HD1 Audio No
Auto
HDMI 1 Audio
ColorStream HD2 Audio
No
HDMI 2 Audio
Auto
Navigate
ENTER
Select
CH RTN
Note: The analog audio terminals for the ColorStream HD and
HDMI inputs are used in common. When the ColorStream HD
1 (or 2) audio mode is set to Yes, the HDMI 1 (or 2) audio mode
is set to Digital and will be grayed out. When the ColorStream
HD 1 (or 2) audio mode is set to No, the HDMI 1 (or 2) Audio
changes to Auto.
®
HD
No
Yes
Back
Exit
EXIT
HM196 (E/F) Web 213:276