Connection Via Bluetooth - IEM Mobil-O-Graph NG Operating Instructions Manual

4. Hypertension Management Software Client-Server
Read out measurements from 24-hour monitoring from Mobil-O-Graph
Starting situation:
■ Monitor is connected to the PC,
■ Mobil-O-Graph
■ PC is switched on,
■ Mobil-O-Graph
Step Mobil-O-Graph
1)
2) ► Switch off the Mobil-O-Graph
► Disconnect cable (pull the plug from the data
port).
For further analysis of the measurement series see 4.11, Analysing measurements.
4.7.2

Connection via Bluetooth

When using the Mobil-O-Graph
■ Configure monitor in HMS CS,
■ Set the monitor for the patient using HMS CS,
■ Test the monitor and put it on the patient.
After 24-hour monitoring
■ Take the monitor off the patient,
■ Read out measurements from the recorder and save them under patient information.
Mobil-O-Graph
®
is switched on,
®
interface recognises HMS CS.
®
®
®
®
with a Bluetooth connection, follow these steps:
®
, operating instructions, Rev. 5.1 10/2015,
®
PC
► Start HMS CS.
If the program is set up for this, the window
Patient list will appear (see 4.12.7, Extras).
In this case, select a patient (see 4.6.2,
Selecting existing patient)
► In the toolbar, click
The question appears: Assign measurements to
patient with ID number xxx?
► Click
The question appears: Delete patient ID and
measurements from the recorder?
► Click .
After data transmission the window
Measurement series appears.
► If necessary, change the times for the daytime
and night intervals.
► Click
The transmitted measurements are displayed
as a Table of measurements.
32
.
.
.
GmbH
4.7.2