Hid Miniprox Reader - Bosch Access Easy Controller Hardware Manual

Access Easy Controller
6.1

HID MiniProx Reader

1.
2.
3.
Bosch Security Systems
Connect the terminal strip where the cable from the reader is terminated to the proper
connector on the 4-reader board.
Result: The reader LED will alternately flash between red & green for a few seconds, and
the beeper in the reader will beep three times in a sequence of two beeps, short pause,
one beep. The LED will remain lit in red.
Present a card to the reader.
Result: The green LED should light briefly and the reader should sound a short beep. This
indicates that the reader recognized the card.
Depending on the setup of the controller database for the card used in the previous step,
one of two events will occur within a second of the beep in step 2. Note that either
response indicates that the reader is working.
If the card is configured to allow access through the reader, then the LED will light in
green for a few seconds indicating that access has been granted.
Or, if the database has not yet been configured, then the LED will flash between red &
green in a rapid alternating pattern for two to three seconds indicating that access has
been denied.
Hardware Manual
How to Install Reader and Field Devices | en 35
Ver 2.0.0 | 2006.07