Display Of Operating Position; Fault Status Messages, Display Of Errors And Info; Display Of Errors (Faults) With Lockout; Reset - Siemens LME39 Series Basic Documentation

P
P
P

/reset

1 s
P
/reset
<3 s
P

Note!
For meaning of the error and diagnostic codes, refer to the error list in section Error history.
When an error has been acknowledged, it can still be read out from the error history.
44/73
Building Technologies Division
15.1.3

Display of operating position

V h min s %
V h min s %
15.1.4

Fault status messages, display of errors and info

15.1.4.1.

Display of errors (faults) with lockout

V h min s %
15.1.4.2. Reset
V h min s %
V h min s %
Basic Documentation LME39...
15 Operation
Display oP: P1 stands for stage 1.
The display following oP is unit-specific.
Display oP: P2 stands for stage 2.
The display following oP is unit-specific.
The display shows Loc:. The bar under the fault status
message appears.
The unit is in the lockout position.
The current error code is displayed (refer to Blink code
table).
Example: Error code 7
for 1 second, rESEt appears on the
When pressing
/reset
display.
When the button is released, the basic unit will be reset.
When pressing for > 3 seconds, the display shows
/reset
InFo, SEr and then OPErAtE.
When the button is released, the basic unit will be reset.
CC1P7106en
08.12.2017