Advertisement
Quick Links
Advertisement
Summary of Contents for ring Retrofit Alarm Kit Z-Wave
- Page 1 Retrofit Alarm Kit Z-Wave Technical Manual...
- Page 2 Ring Retrofit Alarm Kit - Basic Setup 1. Securely mount the Ring Retrofit Alarm Kit to the wall near the wired alarm panel by using the pre-applied double stick tape on the back of the device or with screws by removing the top cover and inserting the screws through the mounting holes on either side of the device.
-
Page 3: Installation
1. Initiate add flow in the Ring Alarm mobile application – Follow the guided add flow instructions provided in the Ring Alarm Mobile application 2. Scan the QR code found on the package of the Ring Alarm Retrofit Kit or the QR code found on the inside of the top cover of the device. - Page 4 Ring Alarm Mobile application 2. Select add manually and enter the 5 digit DSK pin found on the package of the Ring Alarm Retrofit Kit or the 5 digit DSK pin found on the inside of the top cover of the device.
-
Page 5: Wake-Up Notification
Wake-Up Notification The sensor will wake up every so often to send a Wake-Up Notification to allow the life line master node controller that the sensor is now available for any queued messages that the controller may have for the sensor. The time between Wake-Up Notifications can be configured with the Wake-Up Notification command class to be between 1 and 24 hours with interval steps of 1 minute. - Page 6 Association This sensor has two Association groups with only one node for each group. Group one is a lifeline group who will receive unsolicited messages relating to case tamper notifications, battery level notifications, Wake-Up notifications, and Device Reset Notifications. Group two is intended to be used with multi-channel association for a controller to subscribe to contact switch open/close notifications sent encapsulated from each of the eight endpoints one for each contact switch.
- Page 7 Should be changed soon), and 0xFF (Dead Battery/ Device is no longer operating). To review your warranty coverage, please visit www.ring.com/warranty. © 2019 Ring LLC or its affiliates. Ring, Always Home, and all related logos are trademarks of Ring LLC or its affiliates.
Need help?
Do you have a question about the Retrofit Alarm Kit Z-Wave and is the answer not in the manual?
Questions and answers