THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• Y : Parts extracted from the conductor side.
•
: Internal component.
f
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen
(Conductor Side)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
Caution:
Pattern face side:
Parts on the pattern face side seen
(SIDE B)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(SIDE A)
the parts face are indicated.
• Indication of transistor.
C
Q
These are omitted.
B
E
• Abbreviation
CND : Canadian model
Note: When the complete MAIN board is replaced, refer to
"CHECKING METHOD OF NETWORK CONNEC-
TION" on page 5.
CMT-BT60/BT60B/BT80W/BT80WB
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
•
: Internal component.
f
• C : Panel designation.
Note:
Note:
The components identi-
Les composants identifi és
fi ed by mark 0 or dotted
par une marque 0 sont
line with mark 0 are criti-
critiques pour la sécurité.
cal for safety.
Ne les remplacer que par
Replace only with part
une pièce portant le nu-
number specifi ed.
méro spécifi é.
• A : B+ Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : TUNER
(
) : CD PLAY
<
> : AUDIO IN
[
] : USB
‹‹
›› : Bluetooth
: Impossible to measure
*
• Voltages are taken with VOM (Input impedance 10 M).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
: AUDIO
F
: TUNER
f
J
: CD PLAY
: AUDIO IN
L
: USB
E
a
: Bluetooth
d
: LAN
: Wireless LAN
G
• Abbreviation
CND : Canadian model
Note: When the complete MAIN board is replaced, refer to
"CHECKING METHOD OF NETWORK CONNEC-
TION" on page 5.
• Circuit Boards Location
ANT board
(CMT-BT80W/BT80WB)
TUNER board (CMT-BT60/BT80W),
DAB board (CMT-BT60B/BT80WB)
DAB tuner module
(DAB1)
MAIN board
33
33
CMT-BT60/BT60B/BT80W/BT80WB
KEY-L board
NFC (RC-S801)
(NFC1)
LCD board
MS-091 board
ILLUMI board
power unit
(PWR1)
JACK board
KEY-R board
bluetooth module
(BT1)
WiFi module
(WIFI1)