Exhaust Plenum End Cap - GE AKD-20 AR Installation And Maintenance Manual

DEH-41473

Exhaust Plenum End Cap

The exhaust plenum end cap is attached to the left or right most plenum sections at the end of the equipment assembly (Figure
F.15). The exhaust plenum end cap must be installed on the exhaust plenum transition adapter (Figure F.14).
Figure F.15 Exhaust plenum end cap details
NOTICE: Use of optional flange clips (Figure F.10) may be
used in lieu of the #12-24 x 7/8 inch hardware. Two flange
clips may be installed on each long exterior flange and one
flange clip may be installed on each short exterior flange.
Use of the optional flange clips will still require the
installation of the 3/8-16 x 1 inch carriage bolts at each
exterior flange corner.
©2016 General Electric. All rights reserved.
Courtesy of NationalSwitchgear.com
AKD-20 AR / Entellisys AR Low-voltage Switchgear
Appendix F. Exhaust Plenum System Details
82