Sealey HBS2010.V2 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instrutions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
1.1. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.

DO NOT use the Beam Setter in direct sunlight.

DO NOT splash the Beam Setter with water or any other liquid.

DO NOT operate the Beam Setter if it is damaged.

DO NOT use the Beam Setter for purposes other than that for which it is designed.

Avoid sudden changes in temperature.

Avoid sudden vibration.

Keep work area clean and tidy and free from unrelated materials.

Ensure the vehicle handbrake is engaged

Ensure there are no passengers in the vehicle.

When not in use store Beam Setter in a safe, dry, childproof location.

2. INTRODUCTION
Ideal for the garage or bodyshop where space is limited. Suitable for pre-MOT inspection and fulfils the legal obligation of the garage
or bodyshop to return vehicles to the customer in roadworthy condition. Compact design includes shortened mast and view through
aiming device. Suitable for all types of cars, motorcycles and light commercial vehicles (Classes I, II, III, IV, V, VII).
3. SPECIFICATION
Height: . . . . . . . . . . 1380mm
Width:. . . . . . . . . . . . 630mm
Length: . . . . . . . . . . . 550mm
IMPORTANT: This Beam Setter uses a fixed graduated screen in accordance with the requirements of the MOT regulations.
However it must be noted that the HBS2010.V2 is NOT approved by VOSA for conducting tests in accordance with MOT requirements.
4. ASSEMBLY
A Base
B Column
C Release Lever
D Light Box
E Aligner
F Retaining Handle
4.1. Attach the 3 wheels to the base (A) of the unit using long
bolts (axles), washers and nuts.
4.2. Attach base of column (B) to base of unit, using four sets
of bolts, washers and nuts. Column should be positioned so
that two holes in top of column base are in line with wheels.
4.3. Position mid section into column base and fix in place using
two countersunk headed allen bolts.
4.4. Slide the beam setting light box (D) over the top of the
column, squeezing the release lever (C) first. Release the
release lever to lock the light box onto the column.
4.5. Insert retaining handle (F) through top of column B, place a
washer then the aligner (E) onto the threaded end and
tighten.
© Jack Sealey Limited
INSTRUCTIONS FOR:
HEADLAMP BEAM SETTER - COMPACT
HBS2010.V2
MODEL NO:
fig.1
Original Language Version
HBS2010.V2 Issue: 2 - 07/01/16