Sealey LED50WS Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
1.1. GENERAL SAFETY
Ensure the lamp is fully charged before initial use.
9
DO NOT turn the lamp on when it is being charged.
8
DO NOT shine directly into your, another person's or an animal's eyes.
8
DO NOT allow children to use the lamp.
8
DO NOT handle or move the lamp whilst it is being charged.
8
DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
8
DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently
8
recharge the battery at least once every six months of non-use.
1.2. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
‰
DO NOT attempt to open, disassemble, modify or service the battery pack.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 60°C (140°F).
8
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention.
2. INTRODUCTION
i
Supplied with built-in high quality wireless speaker which can easily be connected to your smartphone or tablet to play music. Rubber
coated housing with recessed hook and integral 90° adjustable stand. Battery charge level indicator on the back. Main light has an on/off
power button and when pressed multiple times cycles through two levels of brightness, 500lm and 250lm with a runtime of 4.5hrs/12hrs.
Light produces a beam distance of up to 50m. IPX4 Water Resistant. IK06 Impact rated to withstand falls of up to 1m. Charging time:
6hrs. Light can be used whilst charging. Supplied with USB cable.
3. SPECIFICATION
i
Model No: ............................................................. LED50WS
Battery ..........................................................3.7V 3Ah Li-ion
Charging Time ...................................................................6hr
IP Rating ........................................................................ IPX4
LED Qty ........................................................... 1 x 10W COB
Length ........................................................................ 160mm
Lumen Outputs (low light/full light) ...................250lm / 500lm
Operating time (low light/full light) ......................12hr / 4.5hr
IMPORTANT WARRANTY INFORMATION
The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will provide warranty against mechanical and electrical defect for a period of one year - this DOES NOT cover fair wear and tear.
If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances
we will not replace the battery regardless of whether it is less than one year old.
4. OPERATION
4.1. CHARGING THE TORCH (fig.1)
4.1.1. Connect the USB lead to the socket on the rear of the lamp (fig.1). Plug USB lead into a power supply and turn on.
4.1.2. When the battery has fully charged the battery indicator LEDs will all be lit (fig.1).
4.1.3. The LEDs will light upon initial switch on of either the torch or wireless function to indicate battery charge state and will go off after a
few seconds. When all 4 LEDs are lit the charge level is 100%, 3 LEDs indicate 75%, 2 LEDs indicate 50% and 1 LED indicates 25%.
4.2. OPERATING THE TORCH FUNCTION
4.2.1. Direct the lens away from your eyes before switching on.
4.2.2. The torch ON/OFF button is located on the rear of the lamp (fig.1). The operation sequence is: one press 100% light, two presses
50% light , three presses OFF.
© Jack Sealey Limited
10W COB LED RECHARGEABLE TORCH
WITH WIRELESS SPEAKER
LED50WS
MODEL NO:
Original Language Version LED50WS Issue 2 09/08/19