Husqvarna QTB320W User Manual page 32

32 www.husqvarna-electrolux.se
Problem
The appliance is noisy.
"E0" symbol and current
temperature are displayed
alternately.
The lid does not close com‐
pletely.
The lid is difficult to open.
The lamp does not work.
The compressor operates
continually.
Possible cause
There is no voltage in the
mains socket.
The appliance is not suppor‐
ted properly.
The appliance touches the
wall or other objects.
Temperature sensor failure.
Food packages are blocking
the lid.
There is too much frost in
the appliance.
The lid gasket is dirty or
sticky.
The lamp is defective.
Temperature is set incorrect‐
ly.
Large quantities of food to
be frozen were inserted at
the same time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed proper‐
ly.
The SUPER function is
switched on.
Solution
Connect the appliance to a
different electrical mains
socket. Contact a qualified
electrician.
Check if the appliance
stands stable. Refer to "In‐
stallation/Location" chapter.
Slightly move the appliance.
Refer to "Installation/Loca‐
tion" chapter.
Contact the Authorised
Service Center.
Arrange the packages in the
right way.
Defrost the appliance. Refer
to "Care and cleaning/
Defrosting the appliance"
chapter.
Clean the lid gasket.
Contact the Authorised
Service Center to replace
the LED light.
Refer to "Control panel/
Temperature regulation"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to the climate class
chart on the rating plate or
to the "Installation/Position‐
ing" chapter.
Allow food to cool to room
temperature before storing.
Check if the lid closes prop‐
erly and the gaskets are not
damaged or dirty.
Refer to "Control panel/SU‐
PER function" chapter.