Advertisement
Quick Links
ENGLISH
High Visibility
4mm LED
On / O
Toggle
Switch
High Quality
Piezo Speaker
FITTING THE BATTERIES
1. Turn o unit prior to tting or
replacing batteries
2. Using a cross head
screwdriver unscrew
the two battery cover
screws.
MICRON USER GUIDE
Rod Friendly
Rubber Inlays
Indexed
Ergonomic
Volume
Control
Indexed
Ergonomic
Tone Control
x6 Colour
Cycle Button
3. Pull the tab upwards from the
top of the battery cover.
4. Take care removing the batteries.
Insert new batteries and ensure
correct polarity.
DO NOT over tighten the battery compartment screws,
excessive force will damage the screw threads.
FEATURES
• Weatherproof Sealed Case
• Dual Step Sensitivity
•Digital Circuitry
• D-Tec™ Sensing System (DTSS)
Battery
• Low Battery Drain
Cover
• CNC Machined Rollerwheel - Tru-Run™
Power Out
•Multicolour (x6) LED
Socket (2.5mm)
Rigid 3/8"
SS Thread
5. For best weatherproo ng, ensure
battery cover has a good seal by rmly
pushing lip into the bottom edge of the case
and pivoting it into position.
6. Re- t cover and screws.
www.foxint.com
Advertisement
Related Manuals for Fox digital Micron MX
Summary of Contents for Fox digital Micron MX
- Page 1 ENGLISH www.foxint.com MICRON USER GUIDE Rod Friendly Rubber Inlays High Visibility FEATURES 4mm LED Indexed Ergonomic Volume • Weatherproof Sealed Case Control • Dual Step Sensitivity On / O Toggle Switch •Digital Circuitry • D-Tec™ Sensing System (DTSS) Battery • Low Battery Drain Indexed Cover Ergonomic...
- Page 2 The MX Micron contains an advanced transmitter device, capable of long LOW BATTERY WARNING distances, this is only compatible with the Fox MX receiver. Up to four MX Micron’s can be used at one time with the MX Receiver. When the MX Micron batteries are low the multi-colour LEDs will automatically change to the colour cyan (green-blue).
Need help?
Do you have a question about the digital Micron MX and is the answer not in the manual?
Questions and answers
Hi my fox micron mx alarms haven’t been used for a good 2/3 months I recently tried to use them and all 3 alarms didn’t turn on so I put new batteries in all 3 alarms still nothing when I switch them on? Any help would be appreciated
If your Fox Micron MX alarms won't turn on after replacing the batteries, check the following:
1. Battery Type: Ensure you are using 2 x LR03 AAA 1.5V Alkaline batteries, as rechargeable batteries are not recommended.
2. Battery Condition: Make sure the batteries are good quality and not mixed (e.g., old and new or different types).
3. Proper Insertion: Verify that the batteries are installed correctly, observing the proper polarity.
4. Power Switch: Push down and release the power switch to activate the unit.
5. Battery Leakage: Inspect for any signs of battery leakage or damage inside the battery compartment.
If all these steps are followed and the alarms still won't turn on, further troubleshooting or servicing may be required.
This answer is automatically generated