Table 3. Error Messages - Troxler EGauge 4590 Manual Of Operation And Instruction

Error Messages
The following table displays a list of the gauge error messages,
as well as the possible causes and recommended solutions for
each message.
Error Message
Bad Checksum!
Default Settings
Restored
Cannot Close File
after Writing.
Cannot Initialize
Media
Cannot Open
Printer
Cannot Write to
the File
Cannot Write to
the Printer
A-6

Table 3. Error Messages

Possible Causes
Gauge settings and/or
project data stored in
memory have been
corrupted and default
(factory) settings have
been restored.
An error occurred when
attempting to store data
to a USB storage device.
An error occurred when
trying to access the USB
storage device.
An error occurred when
trying to communicate
with a USB printer.
An error occurred when
attempting to store data
to a USB storage device.
An error occurred when
trying to communicate
with a USB printer.
Solution
Set up user preferences
(such as measurement
mode, count time, and so
on) as described in Chapter
3.
Try to store the data again.
If error recurs, try a
different USB storage
device.
Check that the USB storage
device is installed properly.
If error recurs, try a
different USB storage
device.
Check that the printer is
powered on and is properly
connected to the USB port.
Ensure that the printer is
compatible with the gauge.
Try to store the data again.
If error recurs, try a
different USB storage
device.
Check that the printer is
powered on and is properly
connected to the USB port.
Ensure that the printer is
compatible with the gauge.