Using Your Salt Lamp; Replacing Light Bulb - Levoit Kana Manual

EN

USING YOUR SALT LAMP

1. Place the salt lamp on a hard, flat surface.
Plug in.
2. Press the light control once quickly to turn on
the lamp.
NOTE: Make sure you press quickly, or the
lamp will not turn on.
3. Press and hold the light control for several
seconds to adjust the brightness while the
lamp is on.
4. Each time you press and hold, you will
alternate between dimming and brightening
the light.
5. Press the light control once to turn off the
lamp.
Action
Press once quickly
When lamp is on,
press and hold, then
release at desired
brightness level
6
Effect
Turn lamp on or off
Dim or brighten light

REPLACING LIGHT BULB

NOTE: Make sure the salt crystal is dry before
replacing the light bulb.
1. Turn off and unplug the salt lamp.
2. Carefully flip over the lamp, supporting the
lamp by the crystal.
3. Use a small screwdriver to remove the 2
base screws. Do not remove the center
screw. Set the screws aside in a safe place.
4. Gently lift out the light bulb holder.
5. Carefully set aside the salt crystal on a flat,
stable surface.
6. Remove the bulb from the base socket by
gently turning it counterclockwise.
7. Install a new bulb in the base socket by
gently turning it clockwise.
8. Gently place the light bulb holder back into
the base. Place the cord into the slot on the
wooden base. This will line up the screw
slots.
9. Replace the base screws. Make sure they are
tightly screwed in.