Do you have a question about the PRO9500 and is the answer not in the manual?
Questions and answers
Summary of Contents for rough country PRO9500
Page 2
SAFETY PRECAUTIONS Observe safety precautions for personal safety and the safety of others. Improper equipment operation may result in injury and equipment damage. Read the following carefully before attempting to operate your winch and keep the instructions for future ref- erence.
Page 3
WINCH OPERATION WARNINGS Read the following carefully before attempting to operate your winch and keep the instructions for future reference. The uneven spooling of cable, while pulling a load, is not a problem unless there is a cable pile up on one end of the drum.
Page 4
Cont: Battery: Be sure that the battery is in good condition. Avoid contact with battery acid or other contaminants. Always wear eye protection when working around a battery. Have the engine running when using the winch to avoid damaging the battery. Winch Cable: Be sure that the cable is in good condition and is attached properly Do not use the winch if cable is frayed.
Page 5
It is highly recommended that the winch be used regularly (once a month). Simply power the cable out 15m, free spool 5m and then power back in. This will keep all components in good working condition so that the winch can be relied on when needed. Contact your authorized Rough Country Recovery Systems outlet for technical assistance.
Page 6
For normal self-recovery work, your existing electrical system is adequate. A fully charged battery and proper connections are essential. Run the vehicle engine during winching operations to keep battery charged. For ease of installation the Rough Country Winch control box is already wired to the winch body. It is...
Page 7
PRO9500 FEATURES AND SPECIFICATIONS LINE SPEED AND AMP DRAW (FIRST LAYER) Single line rated pull 9500Lb(4300kg) Motor 5.5HP Series Wound Control Remote switch, 12ft(3.7m)lead Gear train 3 Stage Planetary Gear reduction ratio 265:1 Clutch Sliding Ring Gear Braking Action Automatic In-The-Drum Drum size Diameter 2.5"(63.5mm) Length 8.8"(224mm)
Page 8
PRO12000 FEATURES AND SPECIFICATIONS LINE SPEED AND AMP DRAW (FIRST LAYER) Single line rated pull 12000Lb(5440kg) Motor 6HP Series Wound Control Remote switch 12ft{3.7m)lead Gear train 3 Stage Planetary Gear reduction ratio 265:1 Clutch Sliding Ring Gear Braking Action Automatic In-The-Drum Drum size Diameter 2.52"(64mm) Length 8.82*(224mm) Cable...
Page 9
The warranty applies to the original purchaser of the winch. To obtain any warranty service, you must provide Rough Country with proof of purchase and date of purchase to Rough Country; such as a copy of the original purchase receipt. This warranty does not cover the removal or reinstallation of the winch. Rough Country will;...
Page 10
TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY -Switch Assembly not connected properly *Insert Switch Assembly firmly to the con- nector -Loose Battery Cable *Tighten nuts on cable connectors -Solenoid Malfunctioning *Tap solenoid to free contact, applying 12 Motor does not turn on volts to coil terminal directly.
Page 11
750 HWY 77 EAST NEWBERN, TENNESSEE 38059 By purchasing any item sold by Rough Country, LLC, the buyer expressly warrants that he/she is in compliance with all applicable Federal, State, and Local laws and regulations regarding the purchase, ownership, and use of the item.
Page 12
ACCESSORIES Part # RS125-Snatch Block Part # RS110-Synthetic Winch rope Part # RS1054-JEEP JK Winch Bumper W/ Stinger and RC LED Part # RS108-24’ Wiring Ext Part # RS120-30M Winch Strap...
Need help?
Do you have a question about the PRO9500 and is the answer not in the manual?
Questions and answers