Advertisement
Easy Spreader
®
The EverGreen
spreader+ can be used to apply a wide range of EverGreen
correct settings, or visit Iovethegarden.com.
Assembly Instructions
Step 1
Insert the spreader stand into the two holes at the front of the hopper.
Step 2
Push a wheel firmly onto each end of the axle until it clicks into place.
Step 3
Insert straight ends of the arms into the handle making sure the quick release buttons securely locate into the holes of the
handle.
Step 4
Insert the ends of the handle into matching sockets at the rear of the hopper and ensure that the quick release buttons
securely locate into small hopper holes.
Parts List
•
Handle
•
Arms (2)
•
Hopper assembly with axle and rate control lever
Instructions
+
®
®
and Scotts
Lawn Builder products. Refer to separate sheet for
Advertisement
Table of Contents
Summary of Contents for Evergreen Spreader+
- Page 1 Easy Spreader Instructions ® ® ® The EverGreen spreader+ can be used to apply a wide range of EverGreen and Scotts Lawn Builder products. Refer to separate sheet for correct settings, or visit Iovethegarden.com. Assembly Instructions Step 1 Insert the spreader stand into the two holes at the front of the hopper.
- Page 2 • Stand • Wheels (2) Using your spreader • Set the rate control lever to zero. • Avoid filling the spreader directly on the lawn. • Fill the hopper evenly to of its capacity. • Practice the recommended walking speed of 1m per second. •...
Need help?
Do you have a question about the Spreader+ and is the answer not in the manual?
Questions and answers