Kenworth T410 Driver's Handbook Manual page 64

OPERATING INSTRUCTIONS
When driving, the screen only allows you to toggle which trip is viewed in
the trip odometer and set the active/inactive status.
When parked you can select and view a variety of data collected for each
trip as seen in the list below:
• fuel economy
• average speed
• engine hours
• idle hours
• % idle hours
• fuel used
• idle fuel used
• % idle fuel used
• sweetspot hours
• cruise control hours
• average engine % load
• drive hours
• PTO hours
• % PTO hours
• PTO fuel used
• % PTO fuel used
• PTO economy
The cluster mounted trip reset button is used to zero and clear accumulated
trip data. Short presses toggle between the odometer view, and the 4 trips.
Holding the button when on a particular trip will zero the stored data and
also automatically set the cleared trip to 'active' status.
Using the MCS while in this screen will only activate or deactivate a trip
function.
PTO options in the display will only be shown if the vehicle is equipped
with a PTO.
Page 38 CAT: 8612 November 2019