Table of Contents
Advertisement
AUTODOME inteox 7000i - 2MP (pendant)
Warning!
Ensure that you connect the outgoing power supply wires to the P107 heater connectors (HN
!
and HL). The heater power (XF103) fuse can handle a higher amperage (3.15 A) than the
camera power (XF102) fuse (2.0 A).
6.
7.
8.
Figure 9.6: VG4-PA0 Power Supply Box
1
2
3
4
9. Follow the instructions in Attach Pendant Arm to Power Supply Box, page 30 to continue
the installation.
Bosch Security Systems
Route the 24 VAC outgoing power supply wires into the VG4-PA0 power supply box
through the conduit fitting on the left side of the box.
Cut and trim the 24 VAC power and ground wires with sufficient slack to reach their
connector terminal in the box, but not so long as to be pinched by or to obstruct closing
the cover door.
Attach the supplied 3-pin power plug to the incoming 24 VAC power wires in the box, as
illustrated below.
P101
24V
NC
24V
1 2 3
P106
GND TXD RXD
XD
C+ C-
6 5 4
6 5 4
6 5 4
6 5 4
6 5 4
6 5 4
6 5 4 3 2 1
5 4 3 2 1
5 4
5 4
5 4
5 4
5 4
Incoming 24 VAC Power Supply Wires (from VG4-PSU1/VG4-PSU2 power supply box)
Ground Wire
P101 Connector
Control Data and Video In/Out Wires (analog models only)
Installation Manual (pendant)
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
J102
(LED)
P105
GND TXD RXD
C+ C-
6 5 4 3 2
6 5 4 3 2 1
5 4 3 2
5 4 3 2
3 2
3 2 1
29
2020-07 | 1.0 |
Advertisement
Table of Contents
