Tyre Pressure Monitor System - Cupra Ateca 2020 Owner's Manual

Remove any central wheel trims before fit-
ting snow chains.
WARNING
The use of unsuitable or incorrectly fitted
chains could lead to serious accidents and
damage.
Always the appropriate snow chains.
●
Observe the fitting instructions provided
●
by the snow chain manufacturer.
Never exceed the maximum permitted
●
speeds when driving with snow chains.
CAUTION
Remove the snow chains to drive on roads
●
without snow. Otherwise they will impair
vehicle handling, damage the tyres and
wear out very quickly.
Wheel rims may be damaged or scratch-
●
ed if the chains come into direct contact
with them. CUPRA recommends the use of
coated snow chains.
308
Practical tips

Tyre pressure monitor system

Control lamp
 It lights up
The inflation pressure of one or more wheels is much
lower than the value set by the driver, or the tyre has
structural damage.
In addition, a audible warning sounds and a text mes-
sage is displayed on the instrument panel screen.
Stop the vehicle! Stop the vehicle safely as soon as

possible. Check all tyres and pressures. Replace any
damaged tyres.
 Flashes
System fault
The control lamp flashes for approximately 1 minute
and then lights up permanently.
If the tyre is inflated correctly, switch the ignition off
and on again. Re-calibrate the tyre pressure monitor
›››
indicator page 309 . If the fault continues, go to a
specialised workshop.
Several control and warning lamps light up
for a few seconds when the ignition is switch-
ed on while the function is verified. They will
switch off after a few seconds.
WARNING
›››
Observe the safety warnings
trol and warning lamps on page
Tyre monitor system
Instrument panel: warning of loss of tyre
Fig. 212
pressure.
The tyre pressure monitoring system com-
pares the individual speeds of each wheel
and thus the dynamic radius with the help of
the ABS sensors.
If the rolling circumference of one or more
wheels has changed, the tyre pressure moni-
toring indicator will indicate this on the in-
strument panel through a warning lamp and
a warning to the driver
one specific tyre is affected, its position with-
in the vehicle will be indicated.
Loss of pressure: Check left

tyre pressure!
in Con-
Wheel tread change
83.
The wheel diameter changes when:
Tyre pressure is changed manually.
●
›››
Fig. 212 . When only