Advertisement
SMF SELECTO MODULAR FILTER
INSTALLATION & OPERATIONS MANUAL
For Single & Multi-Cartridge SMF Series Systems
Water Filtration Systems for the Food Service Industry
Installation and Operating Instructions covering all SMF water filtration systems including, but not limited to:
SMF IC600, SMF IC600+, SMF IC620+, SMF IC600+/3, SMF IC620, IC620-2 & IC620-3, SMF IM600 &
IM614, SMF IcePRO, SMF CoffeePRO, SMF Espresso 7500,SMF Espresso 12000,
SteamerGUARD Flash 2000 & 4000, SMF SteamerGUARD 7500, & SMF SteamerGUARD 12000,
Proud Member of:
SMF IC600-S, SMF
DO NOT USE with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system.
certi ed for cyst reduction may be used on disinfected
waters that may contain lterable cysts.
Systems
UM-SMF-IC
Rev. 9-12-07
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Selecto SMF Series
Summary of Contents for Selecto SMF Series
- Page 1 SMF SELECTO MODULAR FILTER INSTALLATION & OPERATIONS MANUAL For Single & Multi-Cartridge SMF Series Systems Water Filtration Systems for the Food Service Industry Installation and Operating Instructions covering all SMF water filtration systems including, but not limited to: SMF IC600, SMF IC600+, SMF IC620+, SMF IC600+/3, SMF IC620, IC620-2 & IC620-3, SMF IM600 &...
- Page 2 1. Installation Precautions 2. Installation Page 2...
-
Page 3: Installation (Continued)
Warranty will be voided if parts are 6. Purge the cartridge so that there is no air remain- cracked and/or broken due to misuse and/or overtightening! Use only Selecto approved, SMF ing by depressing the red button until a steady stream Modular fittings! of water comes out (See Item b. -
Page 4: Maintenance
3. Maintenance Cartridge Replacement Schedule 1. When the line pressure downstream of the filter housing drops to 30 psi or below during system operation, the cartridge(s) needs to be replaced. Occasional dips below 30 psi and back are normal. 2. For system backplate label for ordering informa- tion for cartridge replacements. - Page 5 Leaks All SMF Series Modular Filter Systems are factory pressure tested. It is normal to experience leaks of a few drops of water at the various O-Ring sealed junction points at initial Start-Up only. This will subside after a few minutes as soon as the O-Rings become under pressure and seat properly.
- Page 6 5 5 . . T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g G G u u i i d d e e ( ( c c o o n n ’ ’ t t . . ) ) Bypassing the Filter System The purpose of the Selecto SMF Modular Filter System is to provide consistant safe, clean ingredient water. Bypassing the system is not recommended.
Need help?
Do you have a question about the SMF Series and is the answer not in the manual?
Questions and answers