MEI Conlux CV1000 Quick Start Manual

Status LED
A Status LED assists in diagnosing the condition of
the Series CV1000. The following is a description
of the LED codes, their meanings, and suggested
remedial actions.
Signal Meaning
LED ON Indicates the unit is enabled and
ready to accept a bill.
LED OFF
Indicates that no power has
been applied to the unit.
1 Flash
Indicates that something is
obstructing the bill path.
2 Flashes
Indicates the unit is not enabled.
3 Flashes
Indicates that the bill path
needs cleaning for optimum
performance.
4 Flashes Indicates that something is
obstructing the cross channel
sensor.
5 Flashes Indicates that the magazine is
removed (the unit will not accept
bills without the magazine
attached).
Slow
Unit is defective.
Flashes
Fast The magazine is full of money.
Flashes
Status LED
The CONLUX series CV1000 Bill Validator will
accept the Conlux Free vend, Conlux Value
vend, Conlux low cost Free vend coupons, the
Pepsi coupon, and the Aramark $1.00 coupons.
No action necessary.
Check to ensure that power is applied.
Remove the magazine and LED housing;
inspect for foreign material
Verify configuration.
Check the coin tube levels in the coin
changer. There must be coins in each tube.
Note: Many machines disable the bill
Validator if the machine door is open and
the door switch is not activated or if the
machine is out of product.
Remove the magazine and LED housing
and follow cleaning instructions to clean
the bill path.
Remove the LED housing and look at the
bill path on the housing and inside the unit
for foreign material; clean as necessary.
Reinstall the magazine.
Replace the unit.
Remove money from the magazine.
Suite 200, 3222 Phoenixville Pike
Configuration
Button
Solution
MEI
Malvern, Pa. 19355
Technical Support:
1-800-345-8172
www.meigroup.com
CV1000
BILL VALIDATOR
© MEI 2012 P/N 252657005