Delay Start Button; Setting Mode; Programme Indicator Lights A And B; Audible Signals - Electrolux AEG FAVORIT 35020 VI User Manual

30
Control panel
• To set the washing programme. Refer to the chapter 'Setting and starting a washing
programme'.
• To set the water softener. Refer to the chapter 'Setting the water softener'.
• To deactivate/activate the audible signals. Refer to the section 'Audible signals'.
• To cancel a washing programme in progress. Refer to the chapter 'Setting and starting
a washing programme'.

Delay start button

Use the delay start button to delay the start of the washing programme with an interval
of 3 hours. Refer to the chapter 'Setting and starting a washing programme'.

Setting mode

The appliance is in setting mode when all the programme indicator lights are off and the
end-of-programme indicator light flashes.
The appliance must be in setting mode for these operations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
The appliance is not in setting mode when only one programme indicator light is on. Cancel
the programme to go back to the setting mode. Refer to the chapter 'Setting and starting
a washing programme'.

Programme indicator lights A and B

Apart the selection of the corresponding washing programme, these lights have an auxiliary
functions:
• The adjustment of the water softener level.
• Deactivation/activation of the audible signals.

Audible signals

You can hear an audible signal:
• At the end of the washing programme.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme selection/cancel button until programme indicator light
A flashes and programme indicator light B comes on.
4. Press the programme selection/cancel button again.
– Programme indicator light A comes on.
– Programme indicator light B starts to flash.
5. Wait until programme indicator light A goes off.
– Programme indicator light B continues to flash.
– The end-of-programme indicator light comes on.
The audible signals are activated.
6. Press the programme selection/cancel button again.
– The end-of-programme indicator light goes off.