Table of Contents
Advertisement
6
Settings
6.11.4 Standby Control
You can set the screen standby mode to be applied when an input signal is received.
Setting Standby Control
1
Press
MENU
2
Press
/
3
Press
/
4
Press
/
5
Press
/
S t a n d b y C o n t r o l
Auto
Power-saving mode will activate if no input signals are detected even though a source device is
connected to the display.
The message
On
Power-saving mode will activate if no input signals are detected.
Off
The message
6
The selected option will be applied.
The Standby Control option is only enabled when
If
"No
Refer to page 56 for details about connecting source devices.
on the remote control.
to move to
Setup
and press [
to move to
Advanced Settings
to move to
Standby Control
to move to the option you want and press [
A u t o
O n
O f f
M o v e
E n t e r
"No
Signal" will appear if no source device is connected.
"No
Signal" will appear if no input signals are detected.
Signal" is displayed although a source device is connected, check the cable connection.
].
and press [
].
and press [
].
].
R e t u r n
Source
is set to
PC
or DVI.
143
6 Settings
Advertisement
Table of Contents
